LK166
Home >> Price >> MITSUBISHI >> FX-20P-CAB0
Brand sort

MITSUBISHI FX-20P-CAB0

Country: JAPAN
Name: FX-30 connect PLC cable
Model: FX-20P-CAB0
Market price: U.S.$ 77.97
(The following are the market open price not sales price!)
MITSUBISHI FX-20P-CAB0
Power: 22kw.
Purpose: high frequency braking resistor.
The use rate of the built-in regenerative brake of the transducer can be promoted.
When using the FR-ABR type brake resistor, the short circuit piece between the terminal PR-PX is removed. Does not remove the short circuit chip will lead to overheating of the brake resistor .
The utilization rate of the regenerative braking should be less than the allowable brake use rate in the above table FX-20P-CAB0
With the operating frequency of the brake resistor to reach 300 degrees C or higher, it is necessary to take protective measures and cooling.
MYS type resistor can be used. But please pay attention to the allowable brake use rate FX-20P-CAB0.
Do not remove the terminal P/+ and P1 between the short circuit chip, in addition to connecting the DC reactor .
The installation of thermal relay, to avoid overheating and burn the braking resistor. "MITSUBISHI general purpose AC servo amplifier MELSERVO-J2-Super series.
Rated output: 2.0kw.
Built in positioning function.
Voltage: 3 phase AC200VAC or single phase AC230V.
Compatible with "MR-J2S- CP-S084" - servo amplifier and interface unit "MR-J2S-TO1" positioning by CC-Link
Simply setting the point table FX-20P-CAB0.
AC servo can be used as the driving source of the field network.
Using servo amplifier built-in positioning function, position data and speed data, you can set the CC-Link.
Start, stop and display can also be transmitted through the CC-Link.
Serial communication reduces wiring.
AC servo distributed control system can be easily constructed. "Drive unit.
MITSUBISHI universal AC servo amplifier MELSERVO-J4 series.
Rated output: 30kw.
Interface: universal type.
Power supply: three phase AC200V.
Support position control, speed control, torque control.
Position control too follow the position insstructions FX-20P-CAB0.
When the control is inserted, the position control is performed.
Speed control follows the speed command to control the speed within a certain range.
Torque control to follow the torque command to control the stable torque.
Function of swwitching amplitude FX-20P-CAB0. The increase in the process of switching and stopping,
And in the operation of the use of the switching signal, switching growth.
FX-20P-CAB0 Operation manual / Instructions / Catalog download link: /searchDownload.html?Search=FX-20P-CAB0&select=5


...more relevant model market price >>>>
Related products
MITSUBISHI
Teach box cable
E-20TP-CAB0
MITSUBISHI Teach box cable E-20TP-CAB0
Length: 3 meters. Specification: cale.
MITSUBISHI
RS-422 cable
FX9GT-CAB0
MITSUBISHI RS-422 cable FX9GT-CAB0
Cale length: 3 meters. For FXCPU FX0,
MITSUBISHI
FX-30 connect PLC cable
FX-20P-CAB0
MITSUBISHI FX-30 connect PLC cable FX-20P-CAB0
Length: 1.5m. Specification: FX round co
MITSUBISHI
FX-30 connect PLC cable
FX-20CP-CADP
MITSUBISHI FX-30 connect PLC cable FX-20CP-CADP
Length: 0.3m. Specification: FX round co