MELSECNET/10, MELSECNET/H coaxial.
Input voltage: DC24V.
How to choose MITSUBISHI PLC.
MITSUBISHI PLC options include the choice of MITSUBISHI PLC models, capacity, I/O module, power, etc..
MITSUBISHI PLC distribution I/O points and design MITSUBISHI PLC peripheral hardware circuit
Draw the I/O point of the PLC and the input / output device connection diagram or the corresponding table,
This part also can be carried out in second steps
FX1N-60MR-DS
Design PLC peripheral hardware circuit.
Draw the electrical wiring diagram of the other parts of the system,
Including the main circuit and the control circuit does not enter the PLC, etc..
The electrical schematic diagram of the system composed of I/O PLC connection diagram and PLC peripheral electrical circuit diagram FX1N-60MR-DS.
So far the system''s hardware electrical circuit has been determined. Motor series: low inertia, medium capacity.
Rated output power: 30.0kw.
Rated speed: 1000rpm.
With the brake: without.
Voltage: 400V level.
Shaft end: straight shaft.
The rotor of the servo motor is a permanent magnet, which is controlled by the U/V/W,
The rotor rotates under the action of the magnetic field, and the encoder feedback signal of the motor is given to the driver,
According to the feedback value and the target value, the driver adjusts the rotation angle of the rotor FX1N-60MR-DS.
Accuracy of the servo motor depends on the accuracy of the encoder (number of lines). Extended power supply for CPU module with built-in power supply.
Bus conversion module is required when using. Maximum can be connected to 2 sets. Input type: DC input, positive common end.
Input points: 4 points.
Input response time: 0.5ms below /1.5ms.
Rated input voltage / current: DC24V/4mA.
External connection: 3 wire.
Sensor connection type.
Minimum size of industry.
When installing the module can choose to use the DIN guide rail or screw mounting.
3 wire sensor input. Type: general purpose AC servo amplifier MR-E series.
Rated output: 0.2kw.
Interface type: general purpose pulse interface.
KH003 special mark for Super MR-E.
High performance and easy to operate, reduce work load.
Enhanced systemm cost performance FX1N-60MR-DS.
Highh performance, high precision positioning (servo motor encoder resolution: 131072) .
High response.
Suppression of vibration by adaptive vibration suppression control.
Using personal computer and servo setup software to optimize tuning.
Has 2 types off interfaces:
Position control and speed control with pulse train interface FX1N-60MR-DS.
The analog input interface is used for speed control and torque control.
FX1N-60MR-DS Operation manual / Instructions / Catalog download link:
/searchDownload.html?Search=FX1N-60MR-DS&select=5