MITSUBISHI FX2N-8AD

Analog output expansion board (1 channel).
Can be installed in FX1N, PLC FX1S, providing 1 channel analog input of the board.
Because it is embedded in the PLC installation, so do not need to install space.
Can easily control the speed of the inverter. Number of channels: RS422, 1 channel
.
Configuration of master / local station,
In addition to the other site network with different CC-Link in addition to the main station and the remote station configuration can also be the main station and the local station configuration FX2N-8AD
A local PLC can communicate with the master station PLC and other remote workstations.
MITSUBISHI PLC online debugging.
On-line debugging is the process that will through the simulation debugging to further carry on the on-line unification to adjust FX2N-8AD.
On-line debugging process should be step by step,
From MITSUBISHI PLC only connected to the input device, and then connect the output device, and then connect to the actual load and so on and so on step by step.
If you do not meet the requirements, the hardware and procedures for adjustment FX2N-8AD.
Usually only need to modify the part of the program can be .
MITSUBISHI PLC hardware implementation
Hardware implementation is mainly for the control cabinet and other hardware design and field construction.
Design control cabinet and the operating table and other parts of the electrical wiring diagram and wiring diagram.
Electrical interconnection diagram of each part of the design system.
According to the construction drawings of the site wiring, and carry out a detailed inspection.
Because the program design and hardware implementation can be carried out at the same time,
So the design cycle of the MITSUBISHI PLC control system can be greatly reduced. The length of the line: 10M.
IP level: IP65.
Bending life: standard.
Electric motor power supply cable for HF-KP/HF-MP series (motor shaft with side extraction). 10Mbps Max., master / local station, support Ver.2 CC-Link.
CC-Link is a bus (RS-485) - type open field network which can control and information processing at the same time.
Can be in thhe CC-Link and high-speed trransmission of ON/OFF information from the station equipment, such as bit data, analog information, such as digital data FX2N-8AD.
Connect all kinds of field equipment through CC-Link.
Can connect all kinds of support CC-Link field equipment, according to vvarrious control requirements to build the corresponding system FX2N-8AD.
Use remote device network mode, up to 64 remote equipment such as analog devices, etc..
FX2N-8AD Operation manual / Instructions / Catalog download link: /searchDownload.html?Search=FX2N-8AD&select=5