MITSUBISHI HA-LFS37K1M4

Can be isolated from the output of the programmable controller, the a/b/c contact relay, SSR, Tr output.Memory format: EEPROM.
Number of steps: up to 4000 steps can be used.
Battery support: do not.
Method for writing and deleting: the device is installed on the PLC, and is written and deleted by the peripheral device . Interface: RS232C HA-LFS37K1M4.
Transmission distance: 15 meters.
A1SJ71UC24-R2/R4/PR computer communication components can communicate with PLC, such as computers and other external intelligent devices, and the components are as follows:
Full / half duplex transmission HA-LFS37K1M4
4 special communication protocols.
No protocol and bidirectional mode.
Protocol selection switch function HA-LFS37K1M4.
The optional baud rate, the highest 19 . 2K.
Since the echo diagnostic test. Cable length 0.45 meters.
Extended substrate for connection.MITSUBISHI inverter FR-F740 series.
Voltage level: three phase 400V.
Frequency converter capacity: 500KW.
The main circuit of the inverter can be divided into two categories in general: voltage type is the voltage source of the DC converter for AC inverter,
The filtering of the DC circuit is the capacitance; the current mode is the DC conversion of the current source to the AC inverter,
The DC loop filter is the inductor HA-LFS37K1M4.
Why is the frequency of the inverter voltage proportional to the change?
The electromagnetic torque of any motor is the result of the interaction between the current and the magnetic flux, the current is not allowed to exceed the rated value, otherwise it will cause the heating of the motor.
Therefore, if the magnetic flux decreases, the electromagnetic torque will decrease, which leads to the reduction of the load carrying capacity. Ontology CPU installation to P-ROM program device.Motor series: low inertia, medium capacity.
Rated output power: 8.0kw.
Rated speed: 1000rpm.
With the brake: without.
Shaft end: straight shaft HA-LFS37K1M4.
The rottor of the servo motor is a permanent magnet, which is controlled by the U/V/W,
The rotor rotates under the action of the magnetic field, and the encoder feedback signal of the motor is given to the driver,
According to the feedback value and the ttargget value, the driver adjusts the rotation angle of the rotor HA-LFS37K1M4.
Accuracy of the servo motor depends on the accuracy of the encoder (number of lines).
HA-LFS37K1M4 Operation manual / Instructions / Catalog download link: /searchDownload.html?Search=HA-LFS37K1M4&select=5