MITSUBISHI HC-SFS52G1 1/17

Drive unit.
MITSUBISHI universal AC servo amplifier MELSERVO-J4 series.
Rated output: 30kw.
Interface: universal type.
Power supply: three phase AC200V.
Special specifications: full closed control 4 wire / support mechanical end encoder ABZ phase input / support positioning mode.
Support position control, speed control, torque control .
Position control to follow the position instructions HC-SFS52G1 1/17.
When the control is inserted, the position control is performed HC-SFS52G1 1/17
Speed control follows the speed command to control the speed within a certain range.
Torque control to follow the torque command to control the stable torque.
Function of switching amplitude. The increase in the process of switching and stopping,
And in the operation of the use of the switching signal, switching growth HC-SFS52G1 1/17. Output type: transistor output, drain type.
Output points: 32 points.
OFF leakage current: 0.1mA.
Output protection function.
Rated load voltage / current: DC12V/DC24V/0.1A.
External connection: 1 wire.
40 pin connector type (FCN connector type).
Through the 40 pin connector type (FCN connector type) can be connected to a variety of devices HC-SFS52G1 1/17.
Can be installed along the 6 direction.
Hardware simulation method is to use a number of hardware equipment to simulate the generation of the signal,
The signals are connected to the input end of the PLC system in a hard wired way, and the timeliness is strong.
Software simulation method is in the MITSUBISHI PLC in the preparation of a set of simulation program,
The simulation provides the field signal, which is simple and easy to operate, but it is not easy to guarantee the timeliness.
Simulation of the process of debugging, debugging method can be used to segment, and the monitoring function of programmer. Function extension board for RS-422 communication.
DC5V power consumption: 20mA. Cable length: 30m.
For the connection between the two graphic operations.
Applicable models: GT16, GT15, GT11. Motor series: low inertia, medium capacity.
Using a serial absolute / incremental encoder.
Rated output power: 3.5kw.
Rated speed: 3000rpm.
With the brake: without.
Shaft end: straight shaft.
Performance comparison of servo motor and stepping motor.
Stepper motor as an open-loop control system, and modern digital control technology has the essential link.
In the current domestic digital control system, stepping motor is widely used.
With the emergence of digital AC servo system, AAC servo motor is morre and more used in digital control system HC-SFS52G1 1/17.
In order to adapt to the development trend of digital control, most of the motion control system adopts stepping motor or full digital AC servo motor as executive motor.
Although they are similar in contrroll mode (pulse train and directional signal), there are great differences in performance and application HC-SFS52G1 1/17.
The use performance of the two are compared.
HC-SFS52G1 1/17 Operation manual / Instructions / Catalog download link: /searchDownload.html?Search=HC-SFS52G1 1/17&select=5