MITSUBISHI MR-ENCBL10M-H

Motor series: low inertia, medium and small capacity.
Using a serial absolute / incremental encoder.
Rated output power: 3.5kw.
Rated speed: 2000rpm.
With the brake: without.
Shaft end: straight shaft.
Comparison of single phase induction motor and servo motor.
The working principle of the AC servo motor is similar to that of the single phase induction motor,
But the rotor resistance of the former is much larger than that of the latter,
So the servo motor is compared with the single machine asynchronous motor,
There are three notable features:
1, large starting torque MR-ENCBL10M-H
2, a wide range of operation.
3, no rotation phenomenon.
AC servo motor running smoothly, low noise MR-ENCBL10M-H.
But the control characteristic is non-linear, and because the rotor resistance is big, the loss is big, the efficiency is low,
Therefore, compared with the same capacity DC servo motor, the volume is large and the weight is heavy,
So it is only suitable for 0 . 5-100W small power control system. Total points: 24 points.
Input points: 14 points.
Output points: 10 points.
Voltage: AC220V MR-ENCBL10M-H.
Output type: transistor.
Outline dimension: 90*75*90 .
FX1N series is a very powerful micro PLC,
Can be extended to up to 128 I/O points,
And can increase the special function module or the expansion board.
Communication and data link function options make FX1N in the volume, communication and special function modules and other important applications is very perfect. Three-phase 4 wire type.
Measuring circuit number: 1 circuits.
Measurement items: power consumption (consumption, regeneration), current, voltage, power, power factor, etc..
Power measurement module product group capable of simply measuring various energy information.
With only one module can be used to measure and power consumption (consumption and regeneration), reactive power, current, voltage, power, power factor and frequency of all kinds of detailed information.
No ladder program can continue to monitor the minimum and maximum values, can also perform 2 types of upper / lower limit alarm.
Only in the ON state can be used to measure the output of the output device.
Therefore, the amount of electricity and the quantity of electricity in the unit of the beat can be obtained during the operation of the equipment.

3 phase 3 wire productts can be used to measure up to 4 circuits in one slot,
3 phase 4 wire products can be used to measure up to 3 circuits,
So the electrical energy measurement can be carried out in a small space by the multi circuit products MR-ENCBL10M-H.
For example, a module ccann be used to measure other loads from the control panel trunk MR-ENCBL10M-H.
In addition, Works2 GX (version 1.90U and higher) can be used to easily set parameters.
MR-ENCBL10M-H Operation manual / Instructions / Catalog download link: /searchDownload.html?Search=MR-ENCBL10M-H&select=5