MITSUBISHI MR-J2S-10B

Type: MR-J series.
Rated output: 0.2KW.
Suitable for motor series: HA-ME.
Voltage: single phase AC100V.
It is very helpful to improve the stability of the low speed control of the servo motor.
But there is no direct effect to improve the accuracy of position control.
There are, of course, software compensation that is similar to pitch compensation,
Can improve the physical resolution of the single lap, so as to improve the accuracy of positioning control MR-J2S-10B
This can be effectively used in the use of the robot control of the indexing table.
It is also because of the application of splicing technology,
The rotary encoder will be more widely used in the high precision servo control in the harsh environment MR-J2S-10B.
The use of rotary encoder with 224/ in the servo motor has been used in the servo motor.
Encoder serial communication system, the communication frequency can only be limited to 10M. RS-232C connection (micro computer connection).
Built in clock function.
Applicable models: A985 (-V) /975/970/960GOT. Power: 0.75kw.
Purpose: high frequency braking resistor MR-J2S-10B.
The use rate of the built-in regenerative brake of the transducer can be promoted .
When using the FR-ABR type brake resistor, the short circuit piece between the terminal PR-PX is removed. Does not remove the short circuit chip will lead to overheating of the brake resistor.
The utilization rate of the regenerative braking should be less than the allowable brake use rate in the above table.
With the operating frequency of the brake resistor to reach 300 degrees C or higher, it is necessary to take protective measures and cooling.
MYS type resistor can be used. But please pay attention to the allowable brake use rate.
Do not remove the terminal P/+ and P1 between the short circuit chip, in addition to connecting the DC reactor.
The installation of thermal relay, to avoid overheating and burn the braking resistor. Motor: HA-LH type.
Power: 1.5kw.
Speed: 2000r/min.
According to the types of power supply: can be divided into DC motor and AC motoor MR-J2S-10B.
The structure and workking principle of DC motor can be divided into four parts: brushless DC motor and brushless DC motor .
Brushless DC motor can be divided into: permanent magnet DC motor and DC motor.
DC Motor Division: Series DC motor, DC motor, DC motor and DC motoor MR-J2S-10B.
Permanent magnet DC Motor Division: rare earth permanent magnet DC motor, ferrite permanent magnet DC motor and aluminum nickel Gu Yongci DC motor.
MR-J2S-10B Operation manual / Instructions / Catalog download link: /searchDownload.html?Search=MR-J2S-10B&select=5