MITSUBISHI MR-J3BUS30M-B

3.8 inches.
Surface treatment: anti reflective film.
Protective film color: No.
USB protective cover parts: no openings.
Set number: 5.
Applicable model: GT21. Motor series: medium inertia, medium capacity.
Using a serial absolute / incremental encoder.
Rated output power: 2.0kw.
Rated speed: 1000rpm .
With a brake band.
Shaft end: straight shaft MR-J3BUS30M-B.
The structure of the AC servo motor stator is basically similar to the capacitor split phase single-phase induction motor MR-J3BUS30M-B
The stator is provided with two positions of 90 degrees of mutual difference of the winding, one is the excitation winding Rf, it is always connected to the AC voltage Uf;
The other is to control the winding L, which is connected to the control signal voltage Uc MR-J3BUS30M-B.
So the AC servo motor, also known as the two servo motor. Motor series: medium inertia, medium power.
Rated output power: 1.0kw.
Rated speed: 3000r/min.
Whether to take the brake: No.
Shaft end: Standard (straight).
Protection level: IP65 (IP67).
Features: medium inertia from low speed to high speed three modes for selection, suitable for different applications MR-J3BUS30M-B.
Application examples: transmission machinery, robots, X-Y working platform.
High resolution encoder 131072p/rev (17 bit).
The encoder with high resolution ensures excellent performance and stability at low speed.
All motor dimensions are the same as before and all are compatible with the wiring. Drive: MR-H_ACN series CC-LINK features.
Rated output: 0.4KW.
The test system is composed of two parts, namely, the servo driver, the motor system and the host computer.
The host computer sends the speed command signal to the servo driver,
Servo drives start to run in accordance with the instructions.
In the course of operation, the running data of the servo system is collected by the host computer and the data acquisition circuit,
And carries on the preservation, the analysis and the display to the data. Because the motor is not loaded in this test system,
So compared with the previous two kinds of testing systems, the system has a relativelly small volume,
And the measurement and control circuit of the system is relatively simple,
But it also makes the system can not simulate the actual operation of the servo drive MR-J3BUS30M-B.
Usually, such testing system is only used to test the rotational speeedd and angular displacement of the tested system under no-load condition,
And can not carry on the comprehensive and accurate test to the servo drive MR-J3BUS30M-B.
MR-J3BUS30M-B Operation manual / Instructions / Catalog download link: /searchDownload.html?Search=MR-J3BUS30M-B&select=5