MITSUBISHI MR-J3ENCBL2M-A1-H

Type: HA-FE series.
Rated output: 0.4KW.
Rated speed: 3000r/min.
Electromagnetic brake: No.
Control complex, easy to achieve intelligent,
The electronic commutation method is flexible and can be changed by square wave or sine wave.
Motor maintenance free, high efficiency, low operating temperature,
Electromagnetic radiation is very small, long life, can be used in a variety of environments MR-J3ENCBL2M-A1-H.
AC servo motor is brushless motor, which is divided into synchronous and asynchronous motor,
Synchronous machines are commonly used in motion control,
Its power range, you can do a lot of power MR-J3ENCBL2M-A1-H
Large inertia, the maximum rotation speed is low, and with the increase of power and rapid reduction MR-J3ENCBL2M-A1-H.
So it is suitable for the application of low speed and stable operation .
The rotor of the servo motor is permanent magnet,
Drive controlled U/V/W three phase electric electromagnetic field,
The rotor rotates under the action of the magnetic field,
At the same time the motor comes with the encoder feedback signal to the drive,
According to the feedback value and the target value, the driver is compared,
Adjust the rotor rotation angle MR-J3ENCBL2M-A1-H.
The accuracy of the servo motor is determined by the accuracy of the encoder. Input and output points: 480 points.
Program capacity: 7K step.
Basic command processing speed: 4.4 ~ 5.6us.
Power supply: input AC100 ~ 120/200 ~ 240V/ output 2A DC24V, 0.5A DC5V.
Modular: PLC is the basic components of a separate module.
Medium and large PLC used this way. Easy maintenance.
User program storage capacity: it is a measure of how much the user application can store the number of indicators.
Usually in words or K words as units. 16 bit binary number is a word,
Every 1024 words are 1K words. PLC to store instructions and data in words.
General logical operation instructions each account for 1 words. Timer / counter,
Shift instruction accounted for 2 words. Data operation instructions for 2~4.
Relay output interface circuit of PLC
Working process: when the internal circuit output digital signal 1,
There is a current flowing through, the relay coil has a current, and then the normally open ccontact is closed,

Provide load current and voltage MR-J3ENCBL2M-A1-H.
When the internal circuit outputs a digital signal 0, there is no current flowing through it,
The relay coil does not have a current, and the normally open contact is broken off,
A current or voltage that is discoonnnected from the load MR-J3ENCBL2M-A1-H.
It is through the output interface circuit to the internal digital circuit into a signal to make the load action or not action.
MR-J3ENCBL2M-A1-H Operation manual / Instructions / Catalog download link: /searchDownload.html?Search=MR-J3ENCBL2M-A1-H&select=5