OMRON E5GC-CX0DCM-000

Isolation: Phototriac coupler.
Zero cross function: Yes.
Indicator: Yes.
Rated output load: 20 A at 180 to 400 VAC.
Rated input voltage: 12 to 24 VDC.
Extremely Thin Relays Integrated with Heat Sinks.
Downsizing achieved through optimum design of heat sink.
Mounting possible via screws or via DIN track .
Close mounting possible for linking terminals E5GC-CX0DCM-000.
(Except for G3PA-260B-VD and G3PA-450B-VD-2 E5GC-CX0DCM-000)
Applicable with 3-phase loads.
Replaceable power element cartridges.
Comply with VDE 0160 (finger protection),
with a dielectric strength of 4,000 V between input and load.
Certified by UL, CSA, and VDE (reinforced insulation). The ultra small size, high performance and rich models E5GC-CX0DCM-000.
5.5mm ultra small built-in amplifier .
Maximum detection distance 2.5mm. Workpiece shaking can also be stable detection.
Response frequency 1kHz.
Low consumption current.
Category: DC 3 wire type.
Shape: non shield.
Detection surface: above.
Detection range: 1.6mm.
Output form: PNP.
Action mode: NO. C1000H-CP CPU 62 k words 1024 pts C1000H-CPU01 E5GC-CX0DCM-000. Type: 1A contact type.
Shape: round.
Terminal shape: solder terminal .
Action: alternate.
Display mode: do not display.
Operation Department color: blue.
Large capacity compact type push button switch.
Can also be used as a power switch with a large capacity cut.
Can be switched from micro load (minimum applicable load 1mA DC5V) to large capacity load. Sensing method: Diffuse-reflective Sensors.
Appearance: Horizontal.
Connection method: Pre-wired.
Sensing distance: 200 mm.
Functions: --.
Model: NPN output.
Ordering Information.
Built-in Amplifier Photoelectric Sensors. Time specification: Instantaneous type.
Current setting range: 8 to 26 A.
Operating voltage: 200/220/240 VAC.
Resetting method: Automatic (See note.).
Solid-state Relay Enables Choice of Three.
Operating Functions (Overcurrent, Open,
phase, and Reverse-phase).
Protects 3-phase induction motors and their loads from damage.
Selection and combination of operating functions from overcur,
rent, open-phase, and reverse-phase.
Circuit and output relay operation can be checked by just operat,
ing the test button.
The set time value can be checked easilly because operation time,
is indicated from the start of operation E5GC-CX0DCM-000.
Space-saving, integrated construction.
Note: If the K2CM is used with an inverter, the operating conditions will,
depend on the load wiring length, inverter carrier frequency, basic,
frequency, annd load conditions E5GC-CX0DCM-000. Error will occur in the operating,
values of the overload elements. It is recommended to test operation,
before using the K2CM.
E5GC-CX0DCM-000 Operation manual / Instructions / Catalog download link: /searchDownload.html?Search=E5GC-CX0DCM-000&select=5