Problem sort
MR-J3-20A origin search problem
Time: 5/3/2017 10:48:20 PM
Now encoud MR-J3-20A a MR-J3-20A problem, that is, in the implementation of the servo origin search, hit the DOG signal can not capture the Z phase signal (open collector OP 33 pin), which led to the servo motor can not stop. How do I connect the number 33? Do you need to connect pin 34 (LG control common end)? If you need to connect how to connect? There is OP output voltage is how many V? Current location
Now encoud MR-J3-20A a MR-J3-20A problem, that is, in the implementation of the servo origin search, hit the DOG signal can not capture the Z phase signal (open collector OP 33 pin), which led to the servo motor can not stop. How do I connect the number 33? Do you need to connect pin 34 (LG control common end)? If you need to connect how to connect? There is OP output voltage is how many V? Current location
Re： Time: 5/4/2017 1:44:00 AM
OP is the zero signal output terminal connected to the PLC input pin, the PLC input is connected to the LG COM.
Thank you
Thank you
next one: Fluctuations in the data on the same block all the data have a greater volatility, all the contacts after the off-line try a single point
Last one: Converter EDS file
Related problems
Related products
MITSUBISHI
Battery trunk cable
MR-BT6V2CBL1M
Length: 1 meters.
Purpose: MR-BT6VCASE.
MITSUBISHI
SSCNET III fiber
MR-J3BUS3M
Fier length: 3 meters.
SSCNET III cales st
MITSUBISHI
Encoder cable
MR-ENCBL10M-H
Cale length: 10m.
For MR-J2S-700A 4 /CP/CL
MITSUBISHI
Servo driver
MR-J200B
Type: MR-J_B series.
Rated output: 2.0KW.
Int
Related download