LK166
Home >> Problems >> Q170MCPU and J3 servo
Problem sort

Q170MCPU and J3 servo

Time: 8/22/2017 7:16:17 PM

The contr Q170MCPU is Q170MCPU Q170MCPU, and the servo setting unit is "angle"". Absolute position control system. The load form in virtual mode is "rotating table"". In real mode, K ABS-1 is executed in the moving SFC, and the address is specified at 0 degrees, specifying the corresponding speed. Sometimes, the machine can not return to the zero position, and there is obvious bigger error with the actual zero position of the machine. However, the current value of the shaft feed is 0 as compared with the actual current
Re:   Time: 8/23/2017 3:31:00 AM
What type of OS are you using now?
Thank you

Re:Re:   Time: 8/23/2017 5:55:00 AM
Hello My current OS model is sw8dnc-sv22qf_00j
Re:Re:Re:   Time: 8/23/2017 10:43:00 AM
According to your OS model, there is no problem with your OS version.
Thank you

Related problems
Related products
MITSUBISHI
Motion controller (upgrade)
Q170MCPU-S1
MITSUBISHI Motion controller (upgrade) Q170MCPU-S1
Axis of control: 16. Compact Q170MCPU integra
MITSUBISHI
Motion controller
Q170MCPU
MITSUBISHI Motion controller Q170MCPU
Axis of control: 16. Compact Q170MCPU integra
Related download