LK166
Home >> Problems >> ST how to write interrupt software
Problem sort

ST how to write interrupt software

Time: 5/9/2017 8:46:52 PM

I use X0,xternal ST switch ST signal, ladder diagram programming, interrupt pointer I1000, I1001. With ST programming (programming software GX WORKS2) how to interrupt the pointer? I define the main program EI_M (TRUE), respectively, the preparation of 2 interrupt subroutine, the program how to identify that is interrupted 1, which is interrupted by the 2?
Re:   Time: 5/10/2017 2:22:00 AM
Click on project", interrupt software "program interrupt software settings", "executive program", "MAIN" on the left navigation window, and then click new data to create a new task. Then right-click on the task to create a new block. Then right-click on the task, click "properties", enter an interrupt pointer in the event. X0 rising edge interrupt I001, X0 falling edge interrupt I000, X1 rising edge interrupt when I10
Re:Re:   Time: 5/10/2017 4:46:00 AM
Thank youe interrupt software is interrupt software no use of ST prepared by the example of the project or the relevant electronic version of the information? The information downloaded on your website does not introduce how to build a subroutine, call subroutine, how to build a function block, call the function block and so on. If you can refer to the example project, you can save yourself time.
Re:Re:Re:   Time: 5/10/2017 9:34:00 AM
I'm so so
interrupt software
interrupt software
Related problems
Related products
MITSUBISHI
High speed interrupt module
A1SI61
MITSUBISHI High speed interrupt module A1SI61
A1SI61 is designed to control the application
MITSUBISHI
Interrupt module
AI61-S1
MITSUBISHI Interrupt module AI61-S1
Enter 16 points. Voltage and current: 14mA DC
MITSUBISHI
Interrupt module
AI61
MITSUBISHI Interrupt module AI61
Enter 16 points. Voltage and current: 6/14mA
Related download