Connector A6CON1E MITSUBISHI A6CON1E

Control axis: maximum 8 axes.
Peripheral I/F: by CPU PLC.
Manual pulse generator operation function: can use 3 sets of manual pulse generator.
Synchronous encoder operation function: can use 8 synchronous encoder.
CPU special high speed communication bus, each 0.88ms cycle can exchange 14K data word MITSUBISHI A6CON1E.
Exercise basic performance is about 2 times, sports SFC processing time is reduced by about 1/4 A6CON1E
PLC interrupt program to achieve high-speed synchronization between multiple CPU.
Motion specific instruction.SD memory card 2GB.
Can be used on the Q24DHCPCPU-V.
Can be used on the Q24DHCPCPU-LS.
Can be used on the QnUDVCPU.Master station module supporting AnyWireASLINK system.
Connecting sensor and programmable controller MITSUBISHI A6CON1E.
Free configuration of sensors, control of 512 points of the input and output.
The AnyWireASLINK transmission line (2 lines) can be used for communication to supply power for the sensor, and the sensor can also be conveniently added.
Can through the project software GXWorks2 batch management sensor shedding detection and from the station module settings, etc.,
Substantial savings in time and cost MITSUBISHI A6CON1E. SRAM memory card; capacity: 8M bytes.
Memory card with protective cover.
Support SD memory card.
High speed universal QCPU support SD memory card,
In order to be able to have a memory card port between SD and PC to easily realize data exchange A6CON1E MITSUBISHI.
In addition, the SD memory card and the extended SRAM card can be used simultaneously.
Therefore, the extension of the file register using the extended SRAM card,
SD memory card can be used at the same time to carry out the data file record, a large number of annotation data storage, through the memory card to guide operation A6CON1E MITSUBISHI.
Simply insert the SD memory card, you can automatically record.
Simply insert the SD in the CPU to save the record setting file, you can automatically start recording A6CON1E MITSUBISHI.
Even when remote data collection is required,
After receiving a record setting file by mail and copy it to the SD memory card,
Can immediately start recording.
Better user experience data recording function.
Easy to record, no need to program.
Simply through the special configuration tool wizard to easily complete the settings,
The collected data can be saved in CSV format to SD storage card.
Can be effectively used to save the CSV file to facilitate the creation of a variety of reference materials,
Including daily reports, generate reports and general reports A6CON1E.
These data can be applied to the data analysis, tracing, etc..
To record the change of control data without missing.
Data can be collected in a time interval or in a millisecond time interval,
To record the changge of the specified control data without any omission MITSUBISHI A6CON1E.
Therefore, in the event of failure, can quickly determine the cause, the precise action analysis.