Can monitor and change the value of the soft component. Can also be simple to operate, change the data.
Can display Japanese and english.
Can be installed directly to the PLC, no wiring.
In addition, the use of FX3U-7DM-HLD, can be directly installed on the electrical cabinets.
Analog input points: 4 points (thermocouple, PT, constant voltage input).
Output points: transistor output 4 points, 4 point CT input.
Weight: 0.4KG.
Temperature sensor with 4CH input control output,
Double position control, standard PID control,
Heating and cooling PID control, cascade control.
By using the combination of the analog output module,
PID control of voltage or current can be realized FX3U-7DM-HLD MITSUBISHI
FX3U-7DM-HLD
New with cascade control. Through the master / slave station of the 2 controllers,
According to the temperature change caused by external disturbance, the temperature can be adjusted quickly.
Can connect FX3GA/FX3G, FX3GE, FX3U series.
When connecting to FX3UC or FX3GC, you need FX2NC-CNV-IF or FX3UC-IPS-5V FX3U-7DM-HLD MITSUBISHI. Function: CPU module.
Input and output points: 32 points.
Power supply capacity (DC5V power): 720mA.
Power supply capacity (DC24V service power supply): 500mA.
Input / output mode: DC input (drain) / transistor (drain).
Input points: 16 points.
Output points: 16 points.
Expansion module is more compact, more suitable for small devices!
Small body on the collection of many functions FX3U-7DM-HLD MITSUBISHI.
FX5UC can be connected to the expansion module, compact and convenient,
Suitable for all kinds of small equipment.
Through the rich conversion module,
Can freely connect FX5 and FX3 expansion devices. 8 point analog potentiometer function expansion board.Extending the device for FX1, PLC FX2, on PLC FX2N.
Need to use the conversion cable. Output points: 16 points.
Transistor output large current. Max input / output points: 14 points.
Power supply voltage: 24VDC.
Input points: 8 points.
Output points: 6 points.
Output type: Transistor (source).
Power consumption (W): 6.5.
Weight (kg):0.22.
Size (WxHxD) mm:60x90x49.
All equipment is digital input and output point.
The total I/O points are not more than 30 points, and the input points are less than 16, the output points are less than 14.
Its MT series of PLC can drive 2 way servo or stepper, commonly used in the control systtem for a simple manipulator FX3U-7DM-HLD.
MITSUBISHI FX1S series PLC is suitable for the smallest package,
It is the preferred target for low cost users to seek powerful control over a limited range of I/0.
FX1S provides up to 30 I/O points, and caan be transmitted through serial communication data,
MT models also have the ability to locate, widely used in a variety of small mechanical equipment FX3U-7DM-HLD.