GLC-TMCN01 | Proface Type H temperature input connector GLC-TMCN01

Used for converting the D-Sub 9 pin convex joint to the D-Sub 25 pin concave jointTouch panel operation for RGB input modules (Master - from: Mini-B)Touch screen anti ultraviolet protective film (1 pieces).Applicable to GLC-2600/2500, the need for bus converter (PSL-CONV00).5.7 inches, installed to provide the function of dust and moistureLT4000M (module type DIO), PNP output, DC24V (host) Proface GLC-TMCN01 GLC-TMCN01 15 pin I/O joint (joint Ax1, joint Bx1) and 6 pin I/O connector (joint Cx 1, connector Dx1). Note: joints A and B are different, the joints C and D different.Extended cable for connecting USB (Type-A) (LT) interface.When the man-machine interface is installed to the fixed panel to provide dust proof and moisture proof function Proface GLC-TMCN01. (1)The man-machine interface directly connected MITSUBISHI electric PLC QnA series A/ CPU programming port.Adapter for EX module (5 / set)LT fasteners installed on the control panel (4 / set)COM2 module is applicable for the isolation of COM2 through a variety of hosts and GP3000 connection7 inch widescreen display module installed on the senior panel adapter GP-2400, GP-3400 and GP-4400 series of holes Proface GLC-TMCN01. The MITSUBISHI Q series PLC is connected to GP, length: 5 m.Used for surface protection of man-machine interface from oil and chemical pollution (5 / set).COM1 interface with the cable (RS-232C), used to connect directly to the SYSMAC connection module (or other host)128MB, for the implementation of the picture save, log and data backup and other data management operations, such as compression flash memory card GLC-TMCN01 Proface GLC-TMCN01 Proface. I/O expansion module, including the 8 point relay /1 public endUsed to output the image signal from the host computer to GPApply to GLC-2600/2500Used for surface protection of man-machine interface from oil and chemical pollution (5 / set) GLC-TMCN01 Proface. Transmisssion screen data of the USB cable, PC (Type-A USB) to the man-machine interface USB (Mini-B) GLC-TMCN01. Cable for connecting GP3000 to various modulesThe MITSUBISHI A series PLC is connected to GP, length: 5 m.Stop pin, prevent cable connecction loose USB cable fastening clip (Type-A*1 USB, Mini-B, each 1 interface), used to adjust the thickness of the mounting panel 2mm gasket (1 pieces) Proface GLC-TMCN01.