MITSUBISHI GT15-70PSCW Resist film

For GT1675-VNB / /GT1672-VNB.
Applicable model: GT16. "Protective film for 10.4 inch screen.
Transparent (frame: white), 5.
Applicable model: GT16. Optional features of memory card (Q/QnA/A/FX compatible).
Non extended memory.
Applicable models: A985 (-V) /975/970/A960GOT (-B) /A956WGOT. 2GB flash ROM MITSUBISHI GT15-70PSCW.
Applicable models: GT16, GT15, GT11, HandyGOTApplication: you can transfer the same image data at a high speed (about two seconds per 64KB data) to multiple F940GOT GT15-70PSCW
When programming software is used in the case of Designer2 GT,
You can create a file in HEX Intel format.
Using communication software to transfer data to a ROM writer.
Application Series: F940GOT. Protective film for 4.7 inch screen MITSUBISHI GT15-70PSCW.
Scrub, 5.
Applicable model: GT104. Protective film for 5.7 inch screen.
Transparent (frame: white), 5.
Applicable model: GT11. Cable length: 0.7m.
For the connection between the two graphic operations.
Applicable models: GT16, GT15, GT11. For GT1030/GT1020 (used for operating system project data transfer) without power supply.
Applicable model: GT10. Series: multimedia and advanced features and features of a variety of high-performance models MITSUBISHI GT15-70PSCW.
Screen size: 10.4 inches.
Display color: 256 color or more color.
Installation type: compatible with multimedia and video /RGB.
Resolution: SVGA (800 x 600).
Display device: TFT color (high brightness, wide viewing angle).
Host frame color: black.
Power type: AC100~240V.
Communication interface: with built-in RS-422.
High performance models with multimedia and advanced features and functionality (including embedded communications capabilities).
User storage capacity: 15MB (GT16__-VNB__:11MB).
With HOST USB and device USB port.
Standard Ethernet, RS-422/485 and RS-232 ports.
Support multimedia and video /RGB units.
Analog touch panel.
Do not let the touch screen surface with water drops or other soft things stick to the surface,
Otherwise, the touch screen is easy to mistake that there is a hand touch caused by surface acoustic wave screen is not allowed.
In addition to cleaning the dirt on the surface of the touch screen,
You can use a soft dry cloth or a cleaning agent to clean out the center of the screen carefully,
Or use a dry soft cloth dipped in industrial alcohol or glass cleaning fluid to clean the touch screen surface.
Touch screen response is slow if you use a hand or other touch to touch the surface acoustic wave touch screen,
This shows that it is likely that the touch screen system has been obsolete, the internal clock frequency is too low,
Or because there is water in the surface of the touch screen to make the touch screen mobile, rapid response recovery,
To replace or upgrade the system mustt, or use dry cloth touch screen on the surface of the water GT15-70PSCW.
If the user is operating the touch screen, the direction of the touch move is to the left,
But the cursor of the system moves to the right,
The failure may be due to the conneection of the control box and the touch screen connected to the connector or the touch screen,
Users as long as the direction of the re exchange of it GT15-70PSCW.