MITSUBISHI MR-PWCNK1 Power connector

Motor series: medium inertia, medium capacity.
Using a serial absolute / incremental encoder.
Rated output power: 1.2kw.
Rated speed: 1000rpm.
With the brake: without.
Shaft end: straight shaft.
The structure of the AC servo motor stator is basically similar to the capacitor split phase single-phase induction motor MITSUBISHI MR-PWCNK1.
The stator is provided with two positions of 90 degrees of mutual difference of the winding, one is the excitation winding Rf, it is always connected to the AC voltage Uf;
The other is to control the winding L, which is connected to the control signal voltage Uc MR-PWCNK1
So the AC servo motor, also known as the two servo motor. MR-J2M multi axis servo amplifier expansion unit.
1, the servo controller through the automation interface can be easily carried out the operation module and the conversion of the field bus module,
At the same time using different fieldbus modules to achieve different control modes (RS485, RS232, optical fiber, InterBus, ProfiBus),
And the control mode of general inverter is single MITSUBISHI MR-PWCNK1.
2, the servo controller is directly connected with the rotary transformer or encoder, and the speed and displacement control loop is formed MITSUBISHI MR-PWCNK1.
The general inverter can only form an open loop control system.
3 servo controller of the control parameters (such as steady-state accuracy and dynamic performance) is better than the general inverter. Content: CNP2 connector two.
Purpose: MR-JE-200B to MR-JE-300B, MR-JE-200A to MR-JE-300A with. The cable is required to diagnose the function using the MRConfigurator (servo setup software) amplifier.MITSUBISHI motor universal AC servo amplifier MELSERVO-J3 series.
Rated output: 7.0kw.
Interface type: SSCNET type III fiber communication.
Special specification: suitable for linear servo motor.
Power specification: three phase AC200V.
More advanced real-time automatic tuning by setting response values,
Including the position gain and the gain of speed, all the gain can be adjusted automatically.
32 segment response level can be set.
AAdvanced vibration suppression control MR-PWCNK1.
An optimal vibration control filter value is automatically set by the automatic tuning function to effectively suppress the vibration of the 100Hz frequency that occurs when the driving part stops.
TThe automatic tuning function can effectively restrain the vibration of the end of the mechanical arm and reduce the residual vibration in the machine MR-PWCNK1.