Model: PY (back-mounting), page 15, PCB terminals.
Number of pins: 14 pins.
Models available with finger protection.
are also available.
New screwless models available.
Terminal/mounting: Plug-in/DIN rail via socket.
Control voltage: 48 VDC.
Overcurrent detection: Instantaneous type, W/o start-up lock.
Solid-state, Plug-in Current Sensor.
Applicable to motor overcurrent protection and 3-phase AC current detection.
Inverse-type, start-up lock type, and instantaneous type over,
current sensors available OMRON PY14QN2.
Instantaneous type under current sensor available
PY14QN2
Plug-in design simplifies installation, removal, and wiring.
DIN sized (48 mm x 96 mm). Type: Spot lens.
Spot: Spot dia.: 3 mm.
Cost Revolution Led by UV Curing.
System.
Minimal heat damage thanks to UV-LED irradiation.
New UV LEDs with much higher brightness mounted in heads.
Greater irradiation power to reduce bonding tact time OMRON PY14QN2.
Usage of LEDs that have a long lifetime of 40,000,
hours* drastically reduces running costs.
Ultra compact body that is approximately 1/8th the size,
of a conventional lamp system.
Equipped with a color LCD that makes settings simple and reliable. Time specification: Inverse type.
Current setting range: 50 to 160 A.
Operating voltage: 200/220/240 VAC OMRON PY14QN2.
Resetting method: Manual.
Solid-state Relay Enables Choice of Three.
Operating Functions (Overcurrent, Open,
phase, and Reverse-phase).
Protects 3-phase induction motors and their loads from damage.
Selection and combination of operating functions from overcur,
rent, open-phase, and reverse-phase PY14QN2 OMRON.
Circuit and output relay operation can be checked by just operat,
ing the test button PY14QN2 OMRON.
The set time value can be checked easily because operation time,
is indicated from the start of operation.
Space-saving, integrated construction.
Note: If the K2CM is used with an inverter, the operating conditions willl,
depend on the load wiring length, inverter carrier frequency, basic,
frequency, and load conditions PY14QN2 OMRON PY14QN2. Error will occur in the operating,
values of the overload elements. It is recommended to test operation, Cable leength L: A, 2 OMRON PY14QN2. 0 m; B, 1.75 m.
Connect Connector-Terminal,
Block Conversion Units (XW2@) to,
I/O Units for Programmable,
Controllers with one touch.