MITSUBISHI FR-E540-1.5K-CH TECHNICAL MANUAL PDF

5 in each package.
Application: to protect the surface of the display, to prevent the operation of oil or other material pollution.
The contaminated part of the adhesive film can be replaced FR-E540-1.5K-CH PDF.
Specifications: 120*45mm.
Application Series: F930GOT. MITSUBISHI inverter series: FR-F820.
Voltage level: three phase 200V.
Power: 5.5kw.
SLD converter rated current: 34A.
Structure and function: Standard model FR-E540-1.5K-CH
Type: CA.
Substrate coating: have.
Compatibility with existing models.
Transducer installation size and FR-F700 (P) series of the same, so you do not need to worry about the replacement operation FR-E540-1.5K-CH PDF.
(rectifier separation type will vary)
Also, but also through the use of options (FR-A8TAT), FR-F700 (P) series installed control loop terminal station.
BBuilt in 2 PID arithmetic FR-E540-1.5K-CH Manual. In the inverter can be PID control of the motor state at the same time, used in the control of the external machine FR-E540-1.5K-CH PDF.
No external PID controller is used to control the external machine, so the system cost can be reduced. Input / output type: DC input (drain / source).
Input points: 8 points.
Input and output points: 8 points.
Because all models of FX series are built in high speed counter,
So the high speed control can be realized by the simple procedure MITSUBISHI TECHNICAL MANUAL.
The input of the basic unit is built in the anti jitter filter,
One part as digital filter,
Sensitivity adjustment unit can reach 1ms.
Using high speed counter automatically adjusted to the minimum value.
Through the high cost of the built-in positioning function and the expansion function to increase the number of control axis MITSUBISHI TECHNICAL MANUAL.
Extended function expansion board and special adapter,
Data links and communication with external serial devices.
FX2N extension module.
The expansion module is an input and output expansion device of the power supply from the bassic unit or the expansion unit,
Can choose the relay or crystal output models, to 8 points for the unit to connect MITSUBISHI TECHNICAL MANUAL FR-E540-1.5K-CH TECHNICAL MANUAL.
Can be extended to FX3GA/FX3G, FX3GE, FX3GC, as well as FX3U, FX3UC series,
When connecting to FX3UC or FX3GC, you need FX2NC-CNV-IF or FX3UC-1PS-5V FR-E540-1.5K-CH Manual.
The number of connection points depends on the basic unit and the expansion unit.