MITSUBISHI FR-F740-45K-CHT TECHNICAL MANUAL PDF

Total points: 10 points.
Input points: 6 points.
Output points: 4 points.
Voltage: AC220V.
Output type: transistor.
Outline dimension: 60*75*90.
MITSUBISHI FX1S series PLC is suitable for the smallest package,
It is the preferred target for low cost users to seek powerful control over a limited range of I/0 FR-F740-45K-CHT PDF.
FX1S provides up to 30 I/O points, and can be transmitted through serial communication data,
MT models also have the ability to locate, widely used in a variety of small mechanical equipment FR-F740-45K-CHTInput and output points: 60 points.
Power supply: DC24V.
Input points: 36 points.
Output points: 24 points FR-F740-45K-CHT PDF.
Output form: relay output.
Power consumption: 29W.
Weight: 0.85KG.
Outline dimension: 175x90x86mm.
A free combination of PLC.
FX3G basic unit: 14/24/40/60 point.
FX3GA is a compact PLC, simple design and with the basic functions of the FX3 series.
Through the strengthening of the built-in function and flexible expansion, expanded in various fields of application FR-F740-45K-CHT PDF.
Third generation standard model.
High flexibility.
Suitable for small scale control of high cost.
Control points to 128 points, the use of CC-Link remote I/O can control the maximum 256 points.
High speed operation MITSUBISHI TECHHNICAL MANUAL FR-F740-45K-CHT Manual .
Basic instructions: 0.21 s/ instruction.
Application instruction: 0.5 s/ instruction.
Large capacity memory.
Built in program memory 32000 steps.
EEPROM memory cartridge with program transfer function.
Third generation standard model.
Easy to use integrated models and flexible scalability.
Condensed convenience of using the usual FX3 series MITSUBISHI TECHNICAL MANUAL.
Its high price by the most suitable for small scale control. Output points: 16 points.
Relay output type. Function: extended power unit.
DC5V power supply capacity: 1A.
DC24V power supply capacity: 0.3A. Power: 0.4kw.
Purpose: high frequency braking resistor MITSUBISHI TECHNICAL MANUAL.
The use rate of the built-in regenerative brake of the transducer can be promoted.
When using the FR-ABR type brake resistor, the short circuit piece between the terminal PR-PX is removed. Does not remove the short circuit chip will lead to overheating of the brake resistor.
The utilization rate of the regenerative braking should be less than the allowable brake use rate in the above table.
With the operating frequency of the brake resistor to rreach 300 degrees C or higher, it is necessary to take protective measures and cooling FR-F740-45K-CHT TECHNICAL MANUAL.
MYS type resistor can be used. But please pay attention to the allowable brake use rate.
Do not remove the terminal P/+ and P1 between thhe short circuit chip, in addition to connecting the DC reactor FR-F740-45K-CHT Manual .
The installation of thermal relay, to avoid overheating and burn the braking resistor.