MITSUBISHI FR-F740-S280K-CHT Instruction manual (Applied) PDF

Total points: 32 points.
Input points: 16 points.
Input mode: DC24V (drain / source).
Output points: 16 points.
Output form: Transistor (source).
Connection status: connector FR-F740-S280K-CHT PDF.
In order to extend the input output of the device.
Also has a built-in power supply products.
The maximum number of points for the input and output is 256.
Expansion module: up to 16 units (in addition to the power expansion module)
The total number of CC-Link, AnyWireASLINK, and Bitty series of remote I/O is 512 points FR-F740-S280K-CHT MITSUBISHI inverter FR-F720 series.
Voltage level: three phase 200V.
Frequency converter capacity: 45KW FR-F740-S280K-CHT PDF.
When the ring is opened, the frequency converter is provided with a load of the motor when the motor is operated with a load at a given frequency,
The range of the motor speed in the rated slip ratio (1%~5%) changes.
For the requirements of relatively high precision, even if the load changes are also required to operate at a given speed of the occasion,
Inverter with PG feedback function can be used (selection) FR-F740-S280K-CHT PDF.
If the given acceleration time is too short, the output frequency of the inverter is far more than the change of the speed (electric aangular frequency),
Converter will be due to flow over the current trip, the operation stopped, which is called stall MITSUBISHI Instruction manual FR-F740-S280K-CHT Manual . Use: can choose any 3 signal relay output from the converter standard output signal.
Applicable frequency converter: FR-A700, FR-F700, FR-E700. Max input / output points: 10 points.
Power supply voltage: DC24V MITSUBISHI Instruction manual.
Input points: 6 points.
Output points: 4 points.
Output type: Transistor (source).
Power consumption (W): 19.
Weight (kg):0.3.
Size (WxHxD) mm:60x90x75.
Positioning and pulse output functions: a PLC cell can output 2 point 100KHz pulses at the same time.
PLC is equipped with 7 special positioning instructions,
Including zero return, absolute or relative address expression and special pulse output control MITSUBISHI Instruction manual.
Host has 10 points (6I/4O), 14 points (8I/6O), 20 points (12I/8O), 30 points (16I/14O) of 4 types.
This type of PLC is mainly used in all of the digital input, digital output control point of the device.
Can be directly connected to the 220V city power, built-in 8K step EEPROM memory, no battery,, easy to maintain FR-F740-S280K-CHT Instruction manual.
The series transistor output (MT) of the PLC, can be output 2 100KHz pulse, direct drive servo or stepper motor.
The series PLC can not be brought with the expansion module, but can be installed by the BBD board to extend a small amount of I/O FR-F740-S280K-CHT Manual .
The series 1N through the installation of BD series PLC board, can achieve RS232, RS485, RS422 communication.