MITSUBISHI FR-F740-S250K-CHT Instruction manual (Applied) PDF

Power: 37kw.
Voltage: 400V.
The surge voltage of the motor can be suppressed when the 400V motor is driven by a frequency converter.
Motor suitable for 5 FR-F740-S250K-CHT PDF. 5 to 37kW. Power: 355kw.
Purpose: to suppress the power harmonics.
Connected to the inverter input, can be used to improve the power factor, reduce the input side of the high harmonic current.
According to the motor power used to select AC reactor FR-F740-S250K-CHT
(when the inverter capacity is greater than the motor capacity, is still based on the motor capacity to choose.) Input expansion board (DC24V 4).Total points: 40 points.
Input points: 24 points.
Output points: 16 points FR-F740-S250K-CHT PDF.
Voltage: AC220V.
Output type: transistor.
Outline dimension: 130*75*90.
FX1N series is a very powerful micro PLC,
Can be extended to up to 128 I/O points,
And can increase the special function module or the expansion board.
Communication and data link function options make FX1N in tthe volume, communication and special function modules and other important applications is very perfect FR-F740-S250K-CHT PDF FR-F740-S250K-CHT Manual . Input points: 32 points
Input mode: DC24V (drain / source).
Connection status: connector.
In order to extend the input output of the device.
Also has a built-in power supply products MITSUBISHI Instruction manual.
The maximum number of points for the input and output is 256.
Expansion module: up to 16 units (in addition to the power expansion module)
The total number of CC-Link, AnyWireASLINK, and Bitty series of remote I/O is 512 points. MITSUBISHI inverter FR-E720 series.
Voltage level: 3 phase 200V MITSUBISHI Instruction manual.
Frequency converter capacity: 1.5KW.
In order to ensure the reliability of production, all production machinery in the design of power with drive, there is a certain amount of surplus.
When the motor can not run under full load, in addition to meet the requirements of power driven,
The surplus torque increases the active power consumption, resulting in the waste of electric energy MITSUBISHI Instruction manual.
Speed control method of fan and pump equipmennt traditional by regulating the entrance or exit of the baffle, valve opening to regulate air flow and water flow
, the input power is large, and a large amount of energy consumption in the baffle, the valve in the processs of closure FR-F740-S250K-CHT Manual FR-F740-S250K-CHT Instruction manual.
When using variable frequency control, if the flow rate is reduced, the speed of the pump or fan can be reduced to meet the requirements.