MITSUBISHI FX-10P-E OPERATION MANUAL PDF

Connecting cable for handheld RH GOT and PLC.
Cable length: 10 meters.
Application: RS-422 connection and RS-232C connection. MITSUBISHI inverter series: FR-F840 FX-10P-E PDF.
Voltage level: three phase 400V.
Power: 3.7kw.
SLD converter rated current: 8.3A.
Structure and function: Standard model.
Type: CA.
Substrate coating: have.
2 times the power consumption of the wind turbine and pump and the speed of the 3 power consumption is proportional to the speed of the rotating speed FX-10P-E
Through the speed control of the frequency converter to adjust the air flow, can reduce the power consumption.
Give full play to the performance of the motor FX-10P-E PDF.
The excitation current is always adjusted to the best state, which can improve the efficiency of the motor.
Load torque is smaller, can further improve energy efficiency.
For example, when a general motor is used, the optimal excitation control mode in the 4% motor load torque is about 30% more than that of the V/F control FX-10P-E PDF. Use: can choose any 3 signal relay output from the converter standard output signal.
Applicable frequency converter: FR-A700, FR-F700, FR-E700. FFunction: CPU module FX-10P-E Manual.
Input and output points: 32 points.
Power supply capacity (DC5V power): 720mA MITSUBISHI OPERATION MANUAL.
Power supply capacity (DC24V service power supply): 500mA.
Input / output mode: DC input (drain / source) / transistor (source).
Input points: 16 points.
Output points: 16 points.
Expansion module is more compact, more suitable for small devices!
Small body on the collection of many functions MITSUBISHI OPERATION MANUAL.
FX5UC can be connected to the expansion module, compact and convenient,
Suitable for all kinds of small equipment.
Through the rich conversion module,
Can freely connect FX5 and FX3 expansion devices. Can be isolated to obtain DC24/48/100V, AC100/200V input signal.MITSUBISHI inverter series: FR-F820 MITSUBISHI OPERATION MANUAL.
Voltage level: three phase 200V.
Power: 5.5kw.
SLD converter rated current: 34A.
Structure and function: Standard model.
Type: CA.
Substrate coating: have.
Compatibility with existing models.
Transducer installation size and FR-F700 (P) series of the same, so you do not need to worry about the replacement operation.
(rectifier separration type will vary)
Also, but also through the use of options (FR-A8TAT), FR-F700 (P) series installed control loop terminal station FX-10P-E OPERATION MANUAL.
Built in 2 PID arithmetic. In the inverter can be PID control of the motor state at the same timme, used in the control of the external machine FX-10P-E Manual.
No external PID controller is used to control the external machine, so the system cost can be reduced.