MITSUBISHI MR-J2-350A Specifications and Installation Guide PDF

Length: 1 meters.
Purpose: MR-BT6VCASE. The length of the line: 10m.
IP level: IP67.
Bending life: standard.
Encoder cable for HF-KP/HF-MP/HF-SP/HF-JP/HC-LP/HC-UP series MR-J2-350A PDF. Type: MR-J series.
Rated output: 0.4KW.
Applicable motor series: HA-FF, HA-SE.
Voltage: three phase AC220V.
It is very helpful to improve the stability of the low speed control of the servo motor.
But there is no direct effect to improve the accuracy of position control MR-J2-350A
There are, of course, software compensation that is similar to pitch compensation,
Can improve the physical resolution of the single lap, so as to improve the accuracy of positioning control MR-J2-350A PDF.
This can be effectively used in the use of the robot conntrol of the indexing table MR-J2-350A Manual.
It is also because of the application of splicing technology,
The rotary encoder will be more widely used in the high precision servo control in the harsh environment.
The use of rotary encoder with 224/ in the servo motor has been used in the servo motor MR-J2-350A PDF.
Encoder serial communication system, the communication frequency can only be limited to 10M. Superior high efficiency IPM motor.
Output power: 5.5kw.
Rated speed: 1500r/min.
Voltage level: 200V.
IPM motor MM-EFS series can not be used to run the power frequency power MITSUBISHI Specifications and Installation Guide.
The total wiring length of the IPM motor shall not exceed 100m.
1 inverters can not connect multiple IPM motors at the same time. Drive unit.
MITSUBISHI universal AC servo amplifier MELSERVO-J4 series.
Rated output: 30kw.
Interface: universal type.
Power supply: three phase AC400V MITSUBISHI Specifications and Installation Guide.
Support position control, speed control, torque control.
Position control to follow the position instructions.
When the control is inserted, the position control is peerformed MR-J2-350A Specifications and Installation Guide.
Speed control follows the speed command to control the speed within a certain range.
Torque control to follow the torque command to control the stable torque MITSUBISHI Specifications and Installation Guide.
Function of switching amplitude MR-J2-350A Manual. The increase in the process of switching and stopping,
And in the operation of the use of the switching signal, switching growth.