MITSUBISHI Q173CPU Programming Manual (MELSAP-L) PDF

Positioning: 3 axis, built-in counter function, open collector output type.
Control unit: pulse.
Number of location data: 1/ axis.
Maximum output pulse: 100Kpps Q173CPU PDF.
Counter: 3 channels.
100Kpps.
Counter input signal: DV5~24V.
40 pin connector.
Positioning control using encoder feedback, especially suitable for conveying system and processing machinery, etc..
In the 1 single module, the 3 axis positioning function and the 3 channel counter function are integrated Q173CPU
Positioning module, high-speed counter module combined as a whole,
Can effectively use the board slot and save space. Input / output points: 4096 points Q173CPU PDF.
Size side mode: small end mode.
SD memory card: available.
6.8.1 OS:VxWorks edition.
Advanced information processing and stable I/O control of high-end type.
C language controller is a long term stable supply, high reliability, high performance, flexible MELSEC on the implementation of the C language program revolutionary open platform Q173CPU PDF.
Including pre installed VxWorks,
This C language controller can be used with various modules of the MELSEC-Q series,
Partner products and open source,
Cliient program assets, such as portfolio use to build a variety of systems Q173CPU Manual.
As can be used in all scenarios, can replace the computer, a new computer platform,
C MELSEC language controller stronger, simpler, higher performance, more flexible, in the future will also continue to continue to develop MITSUBISHI Programming Manual. E81WH4W, QE83WH4W special transformer.
Power measurement module product group capable of simply measuring various energy information MITSUBISHI Programming Manual.
With only one module can be used to measure and power consumption (consumption and regeneration), reactive power, current, voltage, power, power factor and frequency of all kinds of detailed information.
No ladder program can continue to monitor the minimum and maximum values, can also perform 2 types of upper / lower limit alarm MITSUBISHI Programming Manual.
Only in the ON state can be used to measure the output of the output device.
Therefore, the amount of electricity and the quantity of electricity in the unit of the beat can be obtained during the operation of the equipment.
3 phase 3 wire products can be used to measure up to 4 circuits in one slot,
3 phase 4 wire products can be used to measure up to 3 circuits,
So the electrical energy measurement can be carried out in a small space by the multi circuit products Q173CPU Programming Manual.
For example, a module ccan be used to measure other loads from the control panel trunk Q173CPU Manual.
In addition, Works2 GX (version 1.90U and higher) can be used to easily set parameters.