OMRON D4JL-2NFA-C7-19 INSTRUCTION sheet PDF

Direction of Operation Key insertion: Horizontal.
Cable length: 5 m.
2NC (Slow-action).
Slim Safety Door Switches with IP67 Rating.
Slim design with a width of only 17 mm D4JL-2NFA-C7-19 PDF.
(three-contact models).
Reversible design allowing either front or rear mounting.
Built-in Switches with two- or three-terminal contact.
construction are available.
Operation Key with rubber mounting hole to absorb vibration and shock D4JL-2NFA-C7-19
IP67 degree of protection. Ratings: Standard load; 5 A at 250 VAC, 4 A at 30 VDC.
Cable: VCTF cable *2.
Actuator: Crossroller plunger.
Cable length : 3 m.
Compact Limit Switch That''s Also D4JL-2NFA-C7-19 PDF.
Thin and Highly Sealed.
Approved by EN, UL, CSA, and CCC (Chinese standard).
(Ask your OMRON representative for information on approved models.)
Sealing characteristics that meet IEC IP67 degree of protection.
Triple-sealed construction:
Plunger section sealed via nitrile rubber packing seal and,
diaphragm; switch section sealed via nitrile rubber cap;
cable entrance sealed via encapsulating material D4JL-2NFA-C7-19 PDF.
Cable lengths of 3 and 5 m available on standard models.
Models also available with UL and CSA-certiffied cables D4JL-2NFA-C7-19 Manual.
Multiple mounting possible with Switches with Plungers OMRON INSTRUCTION sheet.
Models with red LED indicators added to series for easy,
confirmation of operation.
(Set by default to light for non-operation.)
VCTF oil-resistant cables with CE marking.
(Applicable only to standard models.)Ratings: 1 A at 30 VDC.
LED indicator: With indicator.
Actuator: Roller plunger OMRON INSTRUCTION sheet.
Many Models Including Roller Lever.
Switches are Only 16-mm Thick with Connector.
New center roller lever models that enable ganged mounting.
of up to 6 Switches.
Cable connectors for easy Switch replacement.
Triple-seal construction to provide IEC IP67 degree of protection.
Operation indicators available for easy monitoring,
(standard indicator is lit when Switch is not operating) OMRON INSTRUCTION sheet.
Approved by UL and CSA.
(Ask your OMRON representative for Information on approved models.) Actuator: Plunger.
Conduit size: 1-conduit; M20.
Built-in switch mechanism: 2NC/1NO (Slow-action).
A Series of Pull-reset Models Now.
Available.
Lineup includes three contact models with 2NC//1NO and 3NC,
contact forms in addition to the previous contact forms 1NC/1NO and 2NC D4JL-2NFA-C7-19 INSTRUCTION sheet.
M12-connector models are available, saving on labor and,
simplifying replacement.
Standardized gold-clad contacts provide high contact reliability D4JL-2NFA-C7-19 Manual.
Can be used with both standard loads and microloads.
Conforms to EN115, EN81-1 and EN81-2.
Certified standards: UL, EN (TÜV), and CCC.