OMRON D4SL-N3QDG-D INSTRUCTION sheet PDF

Ratings: Standard load; 5 A at 125 VAC.
Cable: VCTF cable *2.
Actuator: Sealed roller plunger.
Cable length : 5 m.
Compact Limit Switch That''s Also D4SL-N3QDG-D PDF.
Thin and Highly Sealed.
Approved by EN, UL, CSA, and CCC (Chinese standard).
(Ask your OMRON representative for information on approved models.)
Sealing characteristics that meet IEC IP67 degree of protection.
Triple-sealed construction:
Plunger section sealed via nitrile rubber packing seal and,
diaphragm; switch section sealed via nitrile rubber cap;
cable entrance sealed via encapsulating material D4SL-N3QDG-D
Cable lengths of 3 and 5 m available on standard models D4SL-N3QDG-D PDF.
Models also available with UL and CSA-certified cables.
Multiple mounting possible with Switches with Plungers.
Modelss with red LED indicators added to series for easy,
confirmation of operation D4SL-N3QDG-D Manual.
(Set by default to light for non-operation.)
VCTF oil-resistant cables with CE marking D4SL-N3QDG-D PDF.
(Applicable only to standard models.)Direction of Operation Key insertion: Vertical.
Cable length: 1 m.
3NC (Slow-action).
Slim Safety Door Switches with IP67 Rating.
Slim design with a width of only 17 mm.
(three-contact models).
Reversible design allowing either front or rear mounting OMRON INSTRUCTION sheet.
Built-in Switches with two- or three-terminal contact.
construction are available.
Operation Key with rubber mounting hole to absorb vibration and shock.
IP67 degree of protection. Specifications: Outputs; PNP (+ common); 16 points.
I/O connections: M3 Screw terminals.
Rated internal circuit power supply voltage:
Supplied from the communications connector OMRON INSTRUCTION sheet.
Rated I/O power supply voltage: 24 VDC.
Allows I/O Expansion with Transistor Terminals.
Wide variety of data, such as maintenance system data,
can be collected without affecting the productivity,
of the control system OOMRON INSTRUCTION sheet D4SL-N3QDG-D INSTRUCTION sheet.
Valuable information can be collected,
and managed through the network, including information,
on the communications power supply.
voltage levels, Unit wear and tear,
and equipment operating informattion D4SL-N3QDG-D Manual.
Expansion via Expansion I/O Units.
With no communications baud rate settings,
required and detachable terminal blocks,
maintenance is easier.