OMRON E5CS-Q1P INSTRUCTION Manual PDF

Name: Tape reflector.
Directional angle: 30° min.
Ambient operating temperature range: 0 to 40°C.
Ambient storage temperature range: -40 to 70°C.
Ambient operating humidity range: 35% to 85% E5CS-Q1P PDF.
Ambient storage humidity range: 35% to 85%.
Degree of protection: IEC IP67.
Accessories: --. Ultra small size, but surprisingly easy installation!
With the addition of M4, 5.4-dia., 6.5-dia E5CS-Q1P size, unshielded,
pre-wired connector model, and connector model, a total of,
108 model variations are available.
High-speed response frequency stably detects moving,
objects: 5 kHz max.
Four indicator lamps for easier indicator positioning E5CS-Q1P PDF.
Special mounting brackets reduce time and efforts for,
installation.
Protective Stainless-steel Spiral Tube against wire,
breakaage is available (M4, M5 only) E5CS-Q1P Manual.
Models also available with standard cables that are 5 m long,
or with robot (bending-resistant) cables E5CS-Q1P PDF. Size: 48 * 48mm, terminal type.
Category: control output 1 point type (power supply AC100 ~ 240V).
Shell color: black.
Control output: relay output.
Control mode: standard or heating cooling.
Auxiliary output points: 2 points.
Heater break, SSR fault detection function: single phase heater detection function OMRON INSTRUCTION Manual.
Event entry point: 2.
Transfer output: -.
Communication: RS-485.
New program type.
A new type of liquid crystal with high performance cost ratio is adopted in the 256 paragraph,
Visual angle, contrast can be improved.
Can be set up to 8 procedures (mode) x 32 (step) procedure OMRON INSTRUCTION Manual.
High resolution 5 bit display / can display 0.01 degrees C (to achieve a small size of 48 x 48mm).
High speed sampling period 60ms.
Full of all models (capable of thermocouple /Pt/ analog input switching),
1 machines to support a variety of sensors.
Add PV/SV state display function, to see the state of the thermostat
(automaatic / manual, RUN/RESET, alarm),
Interactive display PV/SV OMRON INSTRUCTION Manual E5CS-Q1P INSTRUCTION Manual.
By supporting software (Ver.4.3 CX-Thermo),
In simple arithmetic functions (AND/OR logic and delay).
Setting the program settings that can performm flexible contact output E5CS-Q1P Manual.
The control output ON/OFF times counting function can predict the fault of the internal relay of the temperature controller.