MITSUBISHI FX2N-48ER-DS datasheet PDF

The built-in I/O function (Location: 1 axis) of the pulse output is converted to a differential drive output.Function extension board for RS-485 communication.
No DC24V consumption, no occupancy of the input output (FX1S and FX1N of the host computer). Cable flat cable;
Connector with 20 pin installed at both ends of the fuse FX2N-48ER-DS PDF.
Length 3M. Can be isolated from the output of the programmable controller, the a/b/c contact relay, SSR, Tr output FX2N-48ER-DSMITSUBISHI inverter series: FR-A820.
Voltage level: three phase 200V.
Power: 11kw.
SLD converter rated current: 63A.
Structure and function: Standard model.
Type: CA.
Substrate coating: have.
Parameters can be selected by 4 different rated current and different overload rating (SLD (ultra light load) rated, LD (light load) rating, ND (general load) rating, HD (weight) FX2N-48ER-DS PDF.
Type load) for selection.
You can choose the most suitable frequency converter for use; and by selecting a transducer with a SLD or LD rated level,
Be able to reduce the size of the device (compared with the FR-A700 series, to reduce the volume of equipment).
For applications that require high torque at low speeds, the HD rating is the most suitable FX2N-48ER-DS PDF.
The controller is used to control and monitor the frequency converter through the network.
Standard corresponding RS-485 communication (MITSUBISHI converter protocol, Modbus-RTU protocol) data transmission speed up to 115200bps. Station type: intelligent equipment station.
Remote input / output: 128 points.
Remote register: 32.
Occupied points: 8 points.
Transfer speed: 10Mbps.
Power supply: 240mA DC24V.
Weight: 0.3kg.
FX3U-64CCL can be connected to the FX-PLC as an intelligent device station.
In addition, through the connection of the various manufacturers of machinery, can be used to set up the system.
Can be connected to FX3GA, FX3GE, FX3GC, FX3U and FX3UC of the host.
Connecting FX3UC, FX3GC requires FX2NC-CNV-IF or FX3UC-IPS-5V FX2N-48ER-DS datasheet. Power: 3.7kw.
Voltage: 200V.
Purpose: high frequency braking resistor.
The braking ability provided by the braking capacity is larger than that provided by the external braking resistor.
Can also be connectedd without built-in brake transistor inverter FX2N-48ER-DS datasheet.
Three types of discharge resistors are available.
Please select according to the required braking torque.