MITSUBISHI MR-E-10AG-KH003 datasheet PDF

Fiber length: 20 meters.
SSCNET III cables (external standard optical fiber control cabinet).
Joints for CN1A and CN1B. The length of the line: 5M.
IP level: IP65.
Bending life: standard.
Electric motor power supply cable for HF-KP/HF-MP series (motor shaft with side extraction). 1 axis servo amplifier MR-E-10AG-KH003 PDF.
MITSUBISHI general AC servo amplifier MELSERVO-J4 series.
Rated output: 7.0kw MR-E-10AG-KH003
Interface: General purpose.
Power supply: three phase AC200V.
Special specification: full closed loop control 4 wire / device end encoder ABZ phase input corresponding support function security unit, support positioning mode.
Servo amplifier supporting universal interface.
Servo amplifier for universal interface.
Speed / torque control of position control and analog voltage command can be carried out by using pulse train command MR-E-10AG-KH003 PDF.
Support Max instruction pulse frequency 4 Mpulses/s.
Improve mechanical properties by high performance motor.
By improving the resolution and processing speed of the encoder,
The rotating servo motor has higher precision and better performance of rotation.
Only open a key type of adjustment function, can be carried out including mechanical resonance filter, high end seismic control II, low pass filter servo gain adjustment MR-E-10AG-KH003 PDF.
Easily start advanced seismic function, it can maximize the mechanical properties.
It can automatically adjust the required response settings automatically. Drive: MR-H_ACN series CC-LINK features.
Rated output: 22KW.
The test system is composed of two parts, namely, the servo driver, the motor system and the host computer.
The host computer sends the speed command signal to the servo driver,
Servo drives start to run in accordance with the instructions.
In the course of operation, the running data of the servo system is collected by the host computer and the data acquisition circuit,
And carries on the preservation, the analysis and the display to the data. Because the motor is not loaded in this test system,
So compared with the previous two kinds of testing systems, the system has a relatively small volume,
And the mmeasurement and control circuit of the system is relatively simple,
But it also makes the system can not simulate the actual operation of the servo drive MR-E-10AG-KH003 datasheet.
Usually, such testing system is only used to test the rotational speeed and angular displacement of the tested system under no-load condition,
And can not carry on the comprehensive and accurate test to the servo drive MR-E-10AG-KH003 datasheet.