MITSUBISHI MR-J3-60B4-RJ006 datasheet PDF

Superior high efficiency IPM motor.
Output power: 55kw.
Rated speed: 1500r/min.
Voltage level: 200V.
IPM motor MM-EFS series can not be used to run the power frequency power.
The total wiring length of the IPM motor shall not exceed 100m.
1 inverters can not connect multiple IPM motors at the same time MR-J3-60B4-RJ006 PDF. Power: 90kw.
Voltage: 200V.
Sine wave filter.
The voltage and current of the motor can be adjusted to a sine wave MR-J3-60B4-RJ006
The sine wave filter is installed to the output terminal of the inverter.
Applicable to FR-A820-03800 (75K) above and FR-A840-02160 (75K) and above frequency converter.
Sine wave filter is equivalent to the operational characteristics of the sine wave power driver, can provide the following benefits MR-J3-60B4-RJ006 PDF.
Low noise.
No surge current.
Reduce motor loss (standard motor). The length of the line: 10M.
IP level: IP65.
Cable outlet direction: the same side of the motor shaft.
Bending life: standard.
Encoder with cable (motor side); for HF-KP/HF-MP series (motor shaft with side extraction). Type: MR-C type.
Symbol 10A for motor models: HC-PQ23.
Power supply voltage: single phase AC220V MR-J3-60B4-RJ006 PDF.
Drive: servo drive in the development of the premise of the frequency conversion technology,
Current loop in the drive,
Speed loop and position loop (frequency converter without the ring) have carried out a more precise control than the general frequency control technology and algorithm,
In function is also a lot stronger than the traditional servo,
The main point can be precise position control.
The control speed and position are controlled by the pulse sequence transmitted by the upper controller,
The internal algorithm of the driver and the faster and more accurate calculation and better performance of electronic devices to make it more superior to the inverter. MITSUBISHI motor universal AC servo amplifier MELSERVO-J3 series.
Rated output: 0.2kw.
Interface type: SSCNET type III fiber communication.
Full closed loop control.
Power specification: single phase AC200V.
High precision and high response location control.
Full closed loop control can be realized by double feedback control method.
Dual feedback control can be performed between the servo motor encoder and the load side encoder.
MR-J3-B-RJ006 can be used in connjunction with a number of manufacturers of linear encoder,
Users can build the system according to their own accuracy requirements MR-J3-60B4-RJ006 datasheet. ABS type linear encoder using serial interface,
No need to install the battery on the serrvo amplifier can easily build the absolute position detection system MR-J3-60B4-RJ006 datasheet.
Flexible system configuration.
Can achieve higher load side positioning accuracy!