OMRON G7SA-4A2B datasheet PDF

Cable with connector (1 to 1) /G79-_C.
L size: 1000mm.
Cable and loose wire cable with loose wire pressing connecting terminal,
Connector cable, MITSUBISHI motor produced PLC connection cable. Contact configuration: Four SPST-NO relays.
Heat sink: Yes.
Built-in SSRs: G3SD-Z01P-PD.
Zero cross function: No G7SA-4A2B PDF.
Applicable output load: 1 A at 3 to 26 VDC (See note 2.).
Rated voltage: 5 VDC, 12 VDC, 24 VDC G7SA-4A2B
Compact Terminal SSR with 4 Outputs.
Easy-to-use SSR block that combines four compact G3S SSRs,
sockets, and heat sink in one unit.
Easy wiring with separate I/O terminal construction.
LED operation indicator.
Special socket used for easy Relay replacement.
Mounts either on DIN track or with screws G7SA-4A2B PDF. Safety outputs *3: Instantaneous, 2(Semiconductor);
OFF-delayed*2, 2 (Semiconductor).
Auxiliary outputs *4: 2(Semiconductor).
Logical AND connection: Inputs, 2(Semiconductor); Outputs, 2(Semiconductor).
No. of input channels: 1 or 2 channels.
Max. OFF-delay time *1: 150 s.
Rated voltage: 24 VDC.
Terminal block type: Spring-cage terminals.
Logical AND Function Adds Flexibility to I/O Expansion G7SA-4A2B PDF.
Facilitates partial or complete control system setup.
Solid-state outputs (excluding Expansion Units).
Detailed LED indications enable easy diagnosis.
TÜV SÜD certification for compliance,
with IEC/EN61508 (SIL3), EN ISO13849-1 (PLe/Safety Category 4).
Approved by UL and CSA.
New unit joins the Series with the following two additional features:
-OFF-delay time of up to 150 seconds can be set.
-Two logical AND connection inputs. Small, highly sensitive 1 pole signal relay.
Small size 12.5 (L) * 7.5 (W) * 10 (H) mm.
Wide range of contact switch area 1mA ~ 1A.
High sensitivity coil 150mW.
Plastic sealed type, excellent environmental performance.
Coil contact between the Part68 FCC standard. (1500V, 10 * 160 s)Slimmest OMRON plug-in SSR with maximum width 6.2 mm.
Long electrical life and high speed switchingg G7SA-4A2B datasheet.
Large plug-in terminals for reliable connection.
G3RV-D (DC load) models can manage resistive loads of 100 µA to 3.0 A.
LED indicator for visible operation checking
Convenient quick electrical connections possible with G3RV puush-in models and cross bar connectors G7SA-4A2B datasheet.
Low power consumption for energy savings.
G3RV is cUL listed when correct relay is matched with the G3RV Socket.