OMRON GT1-OD16DS PROGRAMMING MANUAL PDF

Main contacts: 3PST-NO.
Auxiliary contact: SPST-NC.
Number of input channels: 1 channel or 2 channels.
Reset mode: Manual reset.
Input type: + common GT1-OD16DS PDF.
Rated voltage: 24 VAC/VDC.
Ultra Slim Safety Relay Unit.
Models of width 17.5 mm available with 2 or 3 poles. Models.
of width 22.5 mm with 3 poles also available.
Conforms to EN standards. (TÜV approval).
DIN track mounting possible GT1-OD16DS Name: Slice I/O Units; Analog I/O Units.
Specifications: Analog inputs (current/voltage).
Standards: CE, UC1, L.
"Easy" and "Flexible" system expansion,
with linked CC-Link and CompoNet.
Branching is easily made with CompoNet GT1-OD16DS PDF.
Wiring material cost can be reduced.
Bit-level I/O distribution reduces,
wiring in the system.
A wide variety of CompoNet Slave Units,
contribute to system size reduction.
Seven-segment Display on the Gateway Unit,
helps to detect errors on site.
The Participation Flags and Communications,
Error Flags can be checked at the Host,
Controller to detect the location and,
content of the error GT1-OD16DS PDF. Input terminals: Compact slotted screw terminals (detachable).
Isolation method: Phototriaccoupler.
Zero cross functiion: Yes GT1-OD16DS Manual.
Operation indicator: Yes.
Alarm output: 2 outputs (Heater Burnout Detection,
SSR Short-circuit Failure Detection) OMRON PROGRAMMING MANUAL.
Applicable load (See note.): 2 to 35 A, 100 to 240 VAC.
A New-concept SSR with Built-in.
Current Transformer.
Heater Burnout and SSR Short.
circuit Failure Detection.
Built-in Current Transformer (CT) helps reduce wiring steps OMRON PROGRAMMING MANUAL.
Detects the burnout of any one of a group of heaters.
Detects the burnout of 3-phase heaters.
Detects SSR short-circuit failures.
Error detection level can be easily set with a switch.
Mounts to a DIN track or with screws.
Three types of input terminals available: M3 terminals,
screwless clamp terminals (detachable), or compact slotted,
screw terminals (detachable) OMRON PROGRAMMING MANUAL.
Certified for CSA and EN (TÜV).
The G3PF-2@@B-@@@ Series is UL certified. Easy programming for complex safety control.
Stand-alone Safety Controller for small and mid-sized machinery.
Three types of CPU with different I/O size to suit the application.
Four types of Expansion I/O Unnits for hard-wired diagnosis or standard signals GT1-OD16DS PROGRAMMING MANUAL.
Clear diagnosis and monitoring via Ethernet or Serial connection.
Various kinds of safety devices directly connectable like noncontact,
switches and safety mats.
Easy design, vverification, standardization and reusage of,
safety control by unique programming software GT1-OD16DS Manual.
ISO 13849-1 (PLe/Category 4), IEC61508 (SIL3) certified.