OMRON GX-OD1621 INSTRUCTION MANUAL PDF

Category: relay output.
Points: 16 points (1a * 16).
Public connector side treatment: NPN (corresponding to the source of public).
Rated voltage: DC24V GX-OD1621 PDF.
Pay attention to the use of convenience and space saving,
Relay terminal for 16 point output.
The terminal block is a long and thin type with a width of 135 * Deep 40mm.
It can be easily connected to the common end with the independent contact and short circuit chip GX-OD1621
Terminal units for power supply wiring processing can be extended.
M3.5 can be used with the Y fork type of the compression terminal (terminal width 6.2mm).
Can not use the tool to remove the relay GX-OD1621 PDF. Relay replacement operation is simple.
Equipped with relay type and power FET MOS relay mounted type.
With action indiication LED GX-OD1621 Manual.
DIN guide rail installation, screw mounting common. Classification: Built-in diode model.
PCB terminals.
Highly Reliable, 4-pole Miniature Relay Ideal,
for Sequence Control GX-OD1621 PDF.
Card lift-off employed for greater life and stable quality.
Long endurance and stable quality are assured by card lift-off system.
Mounting interchangeability with MY-series Relays.
Operation indicator mechanism incorporated for at-a-glance,
monitoring of ON/OFF operation OMRON INSTRUCTION MANUAL. In addition, a built-in operation,
indicator model is also included in this Relay Series. Internal I/O common: PNP.
I/O indicators: LED display (yellow).
Unit power supply current consumption:
80 mA max. (for 20.4 to 26.4-VDC power supply voltage)
Weight: 190 g max.
Expansion functions: No OMRON INSTRUCTION MANUAL.
Short-circuit protection function: No.
High-speed digital I/O terminal with the,
screw type terminal block for EtherCAT,
communications.
Detachable screw terminal block facilitates,
the maintenance.
The expansion unit can be connected.
(One expansion unit per one I/O terminal uniit OMRON INSTRUCTION MANUAL GX-OD1621 INSTRUCTION MANUAL. )
Input/output point can be flexibly increased,
depending on the system.
Input response time can be switched for,
high-speed processing.
Selectable node address setting methods:
setting with rotary sswitch and with tool software GX-OD1621 Manual.
When setting the nodes with rotary switch,
setting is easy and node identification becomes,
possible for maintenance.