FX2N-16MT-ES/UL MITSUBISHI FX2N-16MT-ES/UL PLC

Use FX3S-CNV-ADP when connecting to the left of the basic unit of the FX3SA, FX3U, and FX3S.Cable length: 0.5m.
RS-485 terminal unit conversion unit.
Applicable model: GT16.
Max input / output points: 16 points.
Supply voltage: 100 - 240VAC.
Input points: 8 points.
Output points: 8 points FX2N-16MT-ES/UL.
Output type: transistor.
Poower consumption: 30VA.
Weight (kg):0.6.
Size (WxHxD) mm:130x90x87.
Note recording function, Component annotation can be recorded in the program register FX2N-16MT-ES/UL.
Online program editor, online change the program will not lose the working hours or stop production operation.
RUN/STOP switch, running on panel / stop switch easy to operate.
Remote maintenance, remote programming software can monitor, upload or uninstall programs and data via modem communications
Password protection, using a eight digit password to protect your program FX2N-16MT-ES/UL.
Clock function and hour meter function, all of the PLC FX2N has a real-time clock standard.
Continuous scanning function, to define the operation cycle for the application of the continuous scan time MITSUBISHI FX2N-16MT-ES/UL.
Input filter adjustment function, you can use the input filter to smooth the input signal (in the basic unit x000 to x017). Output points: 32 points
Output form: Transistor (source).
Connection status: connector.
In order to extend the input output of the device MITSUBISHI FX2N-16MT-ES/UL.
Also has a built-in power supply products.
The maximum number of points for the input and output is 256.
Expansion module: up to 16 units (in addition to the power expansion module)
The total number of CC-Link, AnyWireASLINK, and Bitty series of remote I/O is 512 points MITSUBISHI FX2N-16MT-ES/UL. Cable flat cable;
Connector with 20 pin installed at both ends of the fuse.
Length 1.5M. MITSUBISHI inverter FR-F720 series.
Voltage level: three phase 200V.
Frequency converter capacity: 0.75KW.
When the inverter is running, the starting current and starting torque of the motor are how?
With the operation of the inverter, with the acceleration of the motor to improve the frequency and voltage,
The starting current is limited to 150% below the rated current (according to the different types of aircraft, 125%~200%).
Starting with power frequency power supply, the starting current is 6~7 times of the rated current, therefore, the impact on the mechanical and electrical.
The inverter drive can be smoothly start (start time longer).
The starting current is 1 FX2N-16MT-ES/UL.2~1.5 times of the rated current, and the starting torque is 70%~120% rated torque;
For the inverter with the torque automatic enhancement function, the starting torque is more than 100%, which can start with full load.