MR-J2S-700B Complete synchronization system with SSCNET high speed serial communication, MITSUBISHI MR-J2S-700B SSCNET interface servo amplifier

The length of the line: 2M.
IP level: IP65.
Cable outlet direction: the same side of the motor shaft.
Bending life: high bending life.
Encoder with cable (motor side); for HF-KP/HF-MP series (motor shaft with side extraction). Drive: MR-H_ACN series SSC-NET compatible AC servo.
Rated output: 3 MR-J2S-700B.5KW.
The servo controller can easily transfer tthe operation module and the field bus module through the automation interface,
At the same time using different fieldbus modules to achieve different control modes (RS485, RS232, optical fiber, InterBus, ProfiBus),
And the control mode of general inverter is single MR-J2S-700B.
The servo controller is directly connected with a rotary transformer or an encoder, which forms a closed loop of speed and displacement control.
The general inverter can only form an open loop control system MR-J2S-700B.
Servo controller of the control parameters (such as steady-state accuracy and dynamic performance) is better than the general inverter.
"MITSUBISHI general purpose AC servo amplifier MELSERVO-J2-Super series.
Rated output: 7.0kw.
SSCNET interface MITSUBISHI MR-J2S-700B.
Voltage: 3 phase AC200VAC or single phase AC230V.
Complete synchronization system with SSCNET high speed serial communication,
The communication cycle between the controller and the servo amplifier is the longest 0.888ms.
Such systems will be able to provide high reliability and high performance MITSUBISHI MR-J2S-700B.
When connecting the servo system with SSCNET,
In the motion system, the parameters of the servo amplifier and the acquisition of the data will be displayed on the motion controller.
Connect a dedicated cable with an amplifier and a controller to form a SSCNET system MITSUBISHI MR-J2S-700B.
This simple connection method reduces the routing time and helps to prevent noise.
Even in the MELSERVO-J2-SUPER series products using high resolution coding standards, the command frequency is no limit.
It is only necessary to add a battery on the servo amplifier, which can form the absolute value system.
Currently there are more than 1000000 high reliability SSCNET servo amplifier networks in use. "Cable length: 3m.
For MR-J2S-11KA (4) MR-J2S-22KA to (4). MITSUBISHI motor universal AC servo amplifier MELSERVO-J3 series.
Rated output: 15.0kw.
Interface type: SSCNET type III fiber communication.
Special specification: suitable for direct drive servo motor.
Power specification: three phase AC200V.
Direct drive system suitable for high speed and high precision!
High speed operation can be realized by direct drive (2m/s), and the traditional mechanical transmission can not achieve such a high speed.
The full closed loop control can be realized by using the position feedback signal from the load side encoder, such as the linear encoder.
The use of a flexible linear servo motor drive components can make the system more compact structure.
The primary side of the linear servo motor (motor coil) is sliding along the secondary side (permanent maagnet) of the motor,
So linear servo motor is especially suitable for large range of applications MR-J2S-700B. In addition, linear servo motor can be connected in series,
Especially for large systems in two axes for high precision synchronous operation.