MITSUBISHI MR-H100BN

The length of the line: 5M.
IP level: IP65.
Direct type.
Bending life: high bending life.
The cable is not shielded.
Electric motor power supply cable for HF-KP/HF-MP series (motor shaft with side extraction). Length: 15 meters.
Cable manufacturing specifications.
When there is no connection options, according to the table under the cable MR-H100BN.
Using a parallel connection or a large size cable for connection between the terminal PG" and "SD" and the motor end encoder MR-H100BN "Memory format: EEPROM.
Number of steps: up to 16000 steps can be used.
Battery support: do not.
Method for writing and deleting: the device is installed on the PLC, and is written and deleted by the peripheral device MR-H100BN. 8.4 inches.
Applicable models: GT27, GT25, GT23 . Q series of basic conversion module, A series of additional basic unit connection adapter unit.
Suitable for: A5 - B/A6 - B.For analog RGB input 2CH (1ch individual display).
Applicable model: GT27. Operation control mode: stored procedure repeated operation.
Built in IE CC-Link.
Input / output points: 4096 points.
Program capacity: 160K step MR-H100BN.
Easy to collect and display the value of soft component .
With simple parameter setting, the value of the soft component can be collected as the record data,
Save to the SD memory card, or through the USB/ Ethernet for real-time monitoring.
Using the data collected by the recording function to support the Unicode text format,
Can be easily recognized by LogViewer GX and spreadsheet software.
In addition, LogViewer GX can also be used to monitor the function of real time,
Easily confirm the time of small changes in the object''s soft components.
These features can be traced back to improve and set up a fault when the commissioning of a great help. Analog channel: 12 channels.
Input / output (resolution): 0 ~ 4000.
Conversion speed: 100ms/12 channel.
Analog module installation.
Power supply: AC85 ~ 132V.
According to the control requirements of the system, using the appropriate design method to design MITSUBISHI PLC program.
Procedures to meet the requirements of system control as the main line,
Write one by one to achieve the control function or the sub task of the program,
Gradually improve the functions specified by the system.
MITSUBISHI PLC detection, fault diagnosis and display and other procedures.
These procedures are relatively independent, generally in the basic completion of the program design and then add.
Hardware simulation method is to use a number of hardware equipment to simulate the generation of the signal,
The signals are connected to the input endd of the PLC system in a haard wired way, and the timeliness is strong MR-H100BN.
Software simulation method is in the MITSUBISHI PLC in the preparation of a set of simulation program,
The simulation provides the field signal, which is simple and easy to operate, but it is not easy too gguarantee the timeliness MR-H100BN.
Simulation of the process of debugging, debugging method can be used to segment, and the monitoring function of programmer.
MR-H100BN Operation manual / Instructions / Catalog download link: /searchDownload.html?Search=MR-H100BN&select=5