MITSUBISHI R32SFCPU

Protective film for 3.7 inch screen.
Scrub, 5.
Applicable model: GT1020. The length of the line: 0.3m.
The cable is not shielded.
Encoder with cable (motor side), for the HF-KP/HF-MP series (motor shaft with side extraction). A series of high performance models that are widely used in network or single machine work environments .
Screen size: 15 inches R32SFCPU.
Display color: 256 color or more color.
Mounting type: panel mounting type R32SFCPU
Resolution: XGA (1024 x 768).
Display device: TFT color (high brightness, wide viewing angle).
Host frame color: black.
Power type: AC100~240V.
Communication interface: with built-in RS-422.
Ideal model for high performance in a network or independent operation environment R32SFCPU.
User storage capacity: 9MB (GT15__-VNB_:5MB).
Device USB port.
Standard RS-232 interface.
Support video /RGB unit.
If the capacitive touch screen is in the middle of the operation, the display resolution or display mode of the touch screen is changed again,
Or the refresh rate of the touch screen controller is adjusted by itself, and the cursor and the touch point can not be felt when the cursor is not corresponding to the touch point,
Must be re calibrated to the touch screen system R32SFCPU.
In order to ensure the normal operation of the touch screen system, in addition to ensure the proper installation of the system software,
Must also remember that in a host do not install two or more than two kinds of touch screen driver,
This will cause the system to run in conflict, so that the touch screen system can not be used properly. "IE Field CC-Link master / local station
Transmission speed: 1Gbps.
Remote input / output: 16384 points.
Remote register: 8192 words.
Can be applied to the serial number of the top 5 for the "13012" and after the CPU module.
Simply set the parameters, you can easily start the network.
Simply use the Works2 GX, set the network parameters in the 1 master station, you can easily connect alll the slave stations R32SFCPU.
Also, when you need to change the system, you only need to change the parameters .
High degree of freedom network
Build star, linear, star and linear mixed model, and ring network,
Therefore, can freely set the scene equipment.
When you use HUB, you justt nneed to connect the cable to the free port to build the network easily,
Additional equipment and re layout of the corresponding is also more simple R32SFCPU. "
R32SFCPU Operation manual / Instructions / Catalog download link: /searchDownload.html?Search=R32SFCPU&select=5