MITSUBISHI A6BSW-P-S4

The input and output module installation number: 5.
Can install module: MELSEC-Q series module.
DIN guide rail mounting adapter type: Q6DIN2.
Size (H) * (44.1mm) * (W) * (D): * 245mm * 98mm.
Substrate module for mounting various modules of MELSEC-Q series.
Extended use of Q series expansion substrates in the following extensions . "Analog channel: 16 channels A6BSW-P-S4.
Input / output (resolution): 0 ~ 4000 A6BSW-P-S4
Conversion speed: 100ms/16 channel.
Analog module installation.
Power supply: AC170V ~ 264V.
According to the control requirements of the system, using the appropriate design method to design MITSUBISHI PLC program.
Procedures to meet the requirements of system control as the main line,
Write one by one to achieve the control function or the sub task of the program,
Gradually improve the functions specified by the system A6BSW-P-S4.
MITSUBISHI PLC detection, fault diagnosis and display and other procedures.
These procedures are relatively independent, generally in the basic completion of the program design and then add.
Hardware simulation method is to use a number of hardware equipment to simulate the generation of the signal,
The signals are connected to the input end of the PLC system in a hard wired way, and the timeliness is strong A6BSW-P-S4.
Software simulation method is in the MITSUBISHI PLC in the preparation of a set of simulation program,
The simulation provides the field signal, which is simple and easy to operate, but it is not easy to guarantee the timeliness.
Simulation of the process of debugging, debugging method can be used to segment, and the monitoring function of programmer. Power: 15kw.
Purpose: to suppress the power harmonics.
Connected to the inverter input, can be used to improve the power factor, reduce the input side of the high harmonic current.
According to the motor power used to select AC reactor.
(when the inverter capacity is greater than the motor capacity, is still based on the motor capacity to choose.) Total points: 20 points.
Input points: 12 points.
Output points: 8 points.

Voltage: AC220V A6BSW-P-S4.
Output ttype: relay .
Outline dimension: 75*75*90.
MITSUBISHI FX1S series PLC is suitable for the smallest package,
It is the preferred target for low cost users to seek powerful control over a limited range of I/0.
FX1S provides up to 30 I/O points, and caan be transmitted through serial communication data,
MT models also have the ability to locate, widely used in a variety of small mechanical equipment A6BSW-P-S4.
A6BSW-P-S4 Operation manual / Instructions / Catalog download link: /searchDownload.html?Search=A6BSW-P-S4&select=5