MITSUBISHI F940GOT-SBD-RH-E

Superior high efficiency IPM motor.
Output power: 37kw.
Rated speed: 1500r/min.
Voltage level: 400V.
IPM motor MM-EFS series can not be used to run the power frequency power.
The total wiring length of the IPM motor shall not exceed 100m.
1 inverters can not connect multiple IPM motors at the same time . Power: 150kw.
Voltage: 200V.
Sine wave filter F940GOT-SBD-RH-E.
The voltage and current of the motor can be adjusted to a sine wave F940GOT-SBD-RH-E
The sine wave filter is installed to the output terminal of the inverter.
Applicable to FR-A820-03800 (75K) above and FR-A840-02160 (75K) and above frequency converter.
Sine wave filter is equivalent to the operational characteristics of the sine wave power driver, can provide the following benefits F940GOT-SBD-RH-E.
Low noise.
No surge current.
Reduce motor loss (standard motor). Protective film for 5.7 inch screen.
Transparent, 5.
Applicable model: GT11. Type: MR-J series.
Rated output: 0.75KW.
Suitable for motor series: HA-ME.
Voltage: three phase AC220V.
It is very helpful to improve the stability of the low speed control of the servo motor F940GOT-SBD-RH-E.
But there is no direct effect to improve the accuracy of position control .
There are, of course, software compensation that is similar to pitch compensation,
Can improve the physical resolution of the single lap, so as to improve the accuracy of positioning control.
This can be effectively used in the use of the robot control of the indexing table.
It is also because of the application of splicing technology,
The rotary encoder will be more widely used in the high precision servo control in the harsh environment.
The use of rotary encoder with 224/ in the servo motor has been used in the servo motor.
Encoder serial communication system, the communication frequency can only be limited to 10M. Input type: DC input, negative public end.
Input points: 8 points.
Enter the response time: 1.5ms the following.
Rated input voltage / current: DC24V/7mA.
Output form: transistor output, source.
Output points: 8 points.
OFF leakage current: 0.3mA.
Output protection function.
Rated load voltage / current: DC24V/1.0A.
External connection: /2 line 2~4 line type.
Waterproof connector type.
Strong waterproof type of IP67 protection grade.
No need to stop the system can be replaced module.
Without the use of tools can be a simple connection, save time.
Terminal resistor built-in.
Can be installed along the 6 direction.
Hardware simulation method is to use a number of hardware equipment to simulate the generation of the signal,
The signals are connected to the input end of thee PLC system in a haard wired way, and the timeliness is strong F940GOT-SBD-RH-E.
Software simulation method is in the MITSUBISHI PLC in the preparation of a set of simulation program,
The simulation provides the field signal, which is simple and easy to operate, but it is not easy too gguarantee the timeliness F940GOT-SBD-RH-E.
Simulation of the process of debugging, debugging method can be used to segment, and the monitoring function of programmer.
F940GOT-SBD-RH-E Operation manual / Instructions / Catalog download link: /searchDownload.html?Search=F940GOT-SBD-RH-E&select=5