MITSUBISHI FR-F840-00083-2-60

Analog channel: 12 channels.
Input / output (resolution): 0 ~ 4000.
Conversion speed: 100ms/12 channel.
Analog module installation.
Power supply: AC170V ~ 264V.
According to the control requirements of the system, using the appropriate design method to design MITSUBISHI PLC program.
Procedures to meet the requirements of system control as the main line,
Write one by one to achieve the control function or the sub task of the program,
Gradually improve the functions specified by the system FR-F840-00083-2-60
MITSUBISHI PLC detection, fault diagnosis and display and other procedures.
These procedures are relatively independent, generally in the basic completion of the program design and then add FR-F840-00083-2-60.
Hardware simulation method is to use a number of hardware equipment to simulate the generation of the signal,
The signals are connected to the input end of the PLC system in a hard wired way, and the timeliness is strong .
Software simulation method is in the MITSUBISHI PLC in the preparation of a set of simulation program,
The simulation provides the field signal, which is simple and easy to operate, but it is not easy to guarantee the timeliness FR-F840-00083-2-60.
Simulation of the process of debugging, debugging method can be used to segment, and the monitoring function of programmer. "1 axes, SSCNET connection type.
Control unit: mm, inch, degree, pulse.
Location data: 600 data / axis.
40 pin connector.
Easy to achieve high speed, high precision positioning control.
Support for multiple types of positioning control,
Including 2 ~ 4 axis 2 axis linear interpolation, circular interpolation, speed control and speed / position control, path switching control, constant speed contrrol etc FR-F840-00083-2-60..
In addittion, can use the "Configurator-QP GX" and other software,
Easy to set, monitor and debug .
Saving wiring through SSCNET cable connections while simultaneously,
The length of the total cable distance up to 30m.
In addition, an absolute position systtemm for determining the origin position is supported by the return data set operation of the origin FR-F840-00083-2-60.
No need for the near point block, such as wiring. "
FR-F840-00083-2-60 Operation manual / Instructions / Catalog download link: /searchDownload.html?Search=FR-F840-00083-2-60&select=5