MITSUBISHI MR-E-10A-KH003

Cable flat cable;
Connector with 20 pin installed at both ends of the fuse.
Length 1.5M. Cable length: 20m.
For connection between FXCPU (MINI-DIN8 pin connector) and GOT.
Connection between FXCPU communication function extension board (MINI-DIN8 pin connector) and GOT.
Applicable models: GT10, GT21 . Control axis: up to 16 axes.
Servo amplifier connection mode: SSCNET III /H (1 system) MR-E-10A-KH003.
Motion controller is a CPU module that is used in combination with a programmable controller CPU MR-E-10A-KH003
Control the programmable controller CPU independently by using motion SFC program.
High precision motion control can be carried out with the programmable controller CPU to share the load MR-E-10A-KH003.
Implementation of high precision motion control for position tracking and series operation .
Can be directly on the input and output modules, analog module, high-speed counter module, such as management, to achieve high-speed input and output.GOT2000/1000 series with IE CC-Link field network communication module.
GOT communication module supporting IE CC-Link field network MR-E-10A-KH003.
Can be used as the IE CC-Link field network of intelligent equipment station, to construct the system containing the display .
Support for the GOT model GT27, GT16, GT15. Input type: DC input, positive common end.
Input points: 16 points.
Enter the response time: 1.5ms the following.
Rated input voltage / current: DC24V/5mA.
External connection: 3 wire.
Sensor connector type (E-CON type).
Using industry standard E-CON type.
Simple wiring through sensor connector.
When installing the module can choose to use the DIN guide rail or screw mounting.
3 wire sensor input. For the QCPU (Q mode) / transport controller CPU (Q Series) bus connection (2 channel) unit standard model.
Applicable models: GT15, GT16, GT27, GT25. Twisted pair cable.
Single bus.
MELSECNET/B (remote I/O station).
According to the control requirements of the system, using the appropriate design method to design MITSUBISHI PLC program.
Procedures to meet the requirements of system control as the main line,
Write one by one to achieve the control function or the sub task of the program,
Gradually improve the functions specified by the system.
MMITSUBISHI PLC initiallization procedure MR-E-10A-KH003. After MITSUBISHI PLC on power, the general need to do some of the initial operation,
In order to start making necessary preparations, to avoid the wrong operation of the system.
The main contents of the initialization program arre:: to some data area, counter and so on,
Data needed to restore some of the data area,
Set or reset some relays,
For some initial state display, etc MR-E-10A-KH003. .
MR-E-10A-KH003 Operation manual / Instructions / Catalog download link: /searchDownload.html?Search=MR-E-10A-KH003&select=5