Used to install the GP3000H series to a commercially available support arm or panel.
Length: 5 meters.7.4 inches, installed to provide the function of dust and moistureThe guide rail mounting adapter is suitable for the host module (PFXLM4B01DAC, PFXLM4B01DAK, PFXLM4B01DDC, PFXLM4B01DDK) without operating the display. Applicable to GLC-2600/2500, the need for bus converter (PSL-CONV00) Proface GP3000H-WMA-01. For the operation screen (5 pieces) (GP3000H standard).Length: 5 meters
GP3000H-WMA-01Stop pin, prevent cable connection loose USB cable fastening clip (Type-A*1 USB, Mini-B, each 1 interface), used to adjust the thickness of the mounting panel 2mm gasket (1 pieces).Disposable film (5 sheets / sets) for protecting screen against contamination of human computer interface.A veneer, for the GP4000 series back loading models of full flush (white, 1)Used to connect the SIEMENS S5 PLC series to the host computer interfaceCOM2 adapter for converting the COM2 interface to the RS-422 terminal blockDurable cable for connecting GP3000H adapter and GP3000H Proface GP3000H-WMA-01. For connecting the GP3000H cable connector and the external output port, the output of the following connectors: serial: D-Sub 9 pin (convex), Ethernet: Jack RJ-45 (Modular), other: terminal block Proface GP3000H-WMA-01. For the direct connection of the MITSUBISHI A series CPU PLC (not to be used at the same time, the programmer) length: 5 meters.The three color tower lamp installed on the fixed panel is connected with the human machine interface through the USB interface GP3000H-WMA-01 Proface. When the man-machine interface is installed to the fixed panel for providing dust proof and moisture proof function (1 pieces) GP3000H-WMA-01 Proface. 5.7 inches thin film used for surface protection of man-machine interface from fingerprints, water droplets, dust and oil pollutioon (5 / set) GP3000H-WMA-01. For the direct connection of the MITSUBISHI FX series CPU PLC (not to be used at the same time, the programmer) length: 1 meters GP3000H-WMA-01 Proface. 15 pin I/O joint (joint Ax1, joint Bx1) and 6 pin I/O connecctor (joint Cx 1, connector Dx1) Proface GP3000H-WMA-01. Note: joints A and B are different, the joints C and D different.Used to prevent disconnection. (1 interface, 5 / set)