CA6-FNCNALL-01 | Proface CA6-FNCNALL-01 FLEX NETWORK joint

GP-230/250/270 series is replaced by ST series, the gap filled with the opening of the panelA veneer, for the GP4000 series back loading models of full flush (white, 1)5.7 inch screen protective cover (1 pieces)B/B+/C FLEX NETWORK Type connector (5)For the direct connection of the MITSUBISHI FX series CPU PLC (not to be used at the same time, the programmer) length: 5 meters Proface CA6-FNCNALL-01 CA6-FNCNALL-01 Disposable film (5 sheets / sets) for protecting screen against contamination of human computer interfaceThe installation of accessories, adjust the size of the GP-411xT panel with the same size of the GP-410xG/W, easy to replace.Engineering documents created by the LT interface to download images and logic programming software through the USB interface Proface CA6-FNCNALL-01. One end is a loose wire, which is used to carry out RS-485 connection between the host and LT.Adapter for EX module (5 / set)Extended cable for connecting USB (Type-A) (LT) interface.10.4 inches (TFT), thin film for surface protection of man-machine interface from fingerprints, water droplets, dust and oil pollution (5 / set).For multi connection communication, length: 5 meters Proface CA6-FNCNALL-01. 10.4 inches (TFT), replace the backlight (2 / set)10.4 inch TFT models applicable parts, for the 10.4 inch man machine interface (TFT) into the 10.4 inch GP2500 (TFT) in the installation of the required accessories CA6-FNCNALL-01 Proface. 5.7 inches thin film used for surface protection of man-machine interface from fingerprints, water droplets, dust and oil pollution (5 / set).A1/A2/B+ DIO Type connector (compression type) (5 / set)10 CA6-FNCNALL-01 Proface. 4 inches (STN), the replacement of the host backlight (2 / set).Used to prevent disconnection of the connection (1 interface, 5 / set).Disposable film (5 sheets / sets) for protecting screen against ccontamination of human computer interface CA6-FNCNALL-01 Proface CA6-FNCNALL-01. Used to prevent accidental operation. Includes 3 mounting screws.Apply to GLC-2600/2500Used to convert the USB interface to the serial interface (RS-232C). A moodem or bar code reader that can be connected to support RS-232C Proface CA6-FNCNALL-01. USB cable fastening clip (Type-A) for preventing disconnection of connection (5 / set).