FN-CABLE2200-31-MS Proface Communication cable (200 m)

Used to connect the 2-Port adapter to GP4000Standard cable for connecting GP3000H adapter and GP3000H.
Length: 5 meters. 10.4 inches and above, used to connect the power cord (5 / set).15 pin I/O joint (joint Ax1, joint Bx1) and 6 pin I/O connector (joint Cx 1, connector Dx1). Note: joints A and B are different, the joints C and D different FN-CABLE2200-31-MS Proface. 7.0/7.5 inch screen protective cover (1 pieces)The MITSUBISHI Q series PLC is connected to GP, length: 5 m FN-CABLE2200-31-MSAUX connector for external output (5 / set).One end is a loose wire, which is used to carry out RS-485 connection between the host and LT.12.1 inches /10.4 inches (STN), the GP installed to the hard panel to provide dust and moisture proof function FN-CABLE2200-31-MS Proface. 12.1 inch /10.4 inch (STN), thin film for surface protection of man-machine interface from fingerprints, water droplets, dust and oil pollution (5 / set).Suitable for A/B+ Type modelsProtection for GP rear connectors (large and small for each of the 1).Touch screen anti ultraviolet protective film (1 pieces).10.4 inches (TFT), the replacement of the host backlight (1).The guide rail mounting adapter is suitable for the host module (PFXLM4B01DAC, PFXLM4B01DAK, PFXLM4B01DDC, PFXLM4B01DDK) without operating the display FN-CABLE2200-31-MS Proface. Applicable to GLC-2600/2500, the need for bus converter (PSL-CONV00).7.4 inches or larger, FLEX NETWORK GLC2300 connector (5 groups)For connecting the GP3000H cable connector and the external output port, the output of the following connectors: serial: D-Sub 9 pin (convex), Ethernet: Jack RJ-45 (Modular), other: terminal block.Connector for connecting a serial port (1)Transmission screen data of the USB cable, PC (Type-A USB) to the man-machine interface USB (Mini-B).For thin film surface protection of man-machine innterface from fingerprints, water droplets, dust and oil pollution (5 / set)Durable cable for connecting GP3000H adapter and GP3000H FN-CABLE2200-31-MS. SD memory card (4GB, MLC, CLASS4).Adapter for EX module (5 / set)Touch screen anti ultraviolet prrotective film (1 pieces) FN-CABLE2200-31-MS. Engineering documents created by the LT interface to download images and logic programming software through the USB interface.