MITSUBISHI F920GOT-BBD-K-E

Remote I/O controller, optical fiber GI.
How to choose MITSUBISHI PLC.
MITSUBISHI PLC options include the choice of MITSUBISHI PLC models, capacity, I/O module, power, etc..
MITSUBISHI PLC distribution I/O points and design MITSUBISHI PLC peripheral hardware circuit
Draw the I/O point of the PLC and the input / output device connection diagram or the corresponding table,
This part also can be carried out in second steps F920GOT-BBD-K-E
Design PLC peripheral hardware circuit.
Draw the electrical wiring diagram of the other parts of the system,
Including the main circuit and the control circuit does not enter the PLC, etc..
The electrical schematic diagram of the system composed of I/O PLC connection diagram and PLC peripheral electrical circuit diagram F920GOT-BBD-K-E.
So far the system''s hardware electrical circuit has been determined. Motor series: low inertia, small capacity.
Using a serial absolute / incremental encoder.
Rated output power: 0.3kw.
Rated speed: 3000rpm.
With the brake: without.
Shaft end: straight shaft.
AC servo motor and brushless DC servo motor in the function of the difference: AC servo is better, because it is a sine wave control, torque ripple small F920GOT-BBD-K-E.
DC servo is a trapezoidal wave. DC servo is simple and cheap. Oil resistant cap for 4.5 inch screen.
Applicable model: hand held GOT. Specification: allowed regeneration power: 300W, resistance value: 40 ohm.
Uses: MR-JE-70B, MR-JE-100B, MR-JE-70A, MR-JE-100A with. Output points: 32 points.
Voltage: DC24V/AC240V, 2A/1 point, 4A/ public end.
OFF leakage current: 0mA.
Output type: relay output.
Response time: 12ms.
8 points / a common end.
50 point terminal station.
Each scanning process. Focus on the input signal sampling. Focus on the output signal to refresh.
Input refresh process. When the input port is closed,
Program in the implementation phase, the input end of a new state, the new state can not be read.
Only when the program is scanned, the new state is read.
A scan cycle is divided into the input sample, the program execution, the output refresh.
The contents of the component image register are changed with the change of the execution of the program.
The length of the scan cycle is determined by the three.
CPU the speed of executing instructions.
Time of instruction.
Instruction count.
Due to the adoption of centralized sampling.
Centralized output mode.
There exist input / output hysteresis phenomena, i.e., the input / output response delay.
PLC selection with the development of PLC technology, more and more types of PLC products,
Function is becoming more and more perfect, and its application is more and more extensive.
Different series of different models of PLC has different performance, applicable occasions also have different emphasis,
Price also has a greater difference. Therefore PLC selection,
Undeer the premise of meeeting the control requirements,
Should consider the best performance to price ratio, a reasonable choice of PLC F920GOT-BBD-K-E.
System program memory for storing system program,
Including management procedures, monitoring procedures, as well as the user program tto do the compiler to compile the process of interpretation F920GOT-BBD-K-E.
Read only memory. Manufacturers use, content can not be changed, power does not disappear.
F920GOT-BBD-K-E Operation manual / Instructions / Catalog download link: /searchDownload.html?Search=F920GOT-BBD-K-E&select=5